56 EN | USING THE REMOTE CONTROL UNIT |
1 |
| ||
| 3 | 2 | + |
| Tab | ||
|
| – | – |
|
| + |
|
| 1 | |
+ |
| 3 |
|
– | 2 |
| |
|
|
|
+
–
A1
2
3
1
Lock hole
B
2 1 3
Knob
1
The
For
Installing The Batteries (RM-V716U or RM-V715U, provided)
The remote control uses two ”AAA (R03)” size batteries. See “General Battery Precautions” ( pg. 85).
1
2 Insert two ”AAA (R03)” size batteries in the correct direction.
3 Replace the battery compartment cover.
Installing The Battery (RM-V700U, optional)
The remote control uses one lithium battery (CR2025).
1 There are 2 ways to pull the battery holder out of the
: Pull out the battery holder while sliding the lock hole.
: Pinch the release tab and pull out the battery holder.
2 Insert the battery in the holder, and be sure to have the “+” mark visible.
3 Slide the holder back in until you hear a click.
•Read the caution concerning lithium batteries in the
Remote sensor
Transmitted beam effective area
5 m (16 ft)
30°
When using the remote control, be sure to point it at the remote sensor. The illustration shows the approximate transmitted beam effective area for indoor use.
The transmitted beam may not be effective or may cause incorrect operation outdoors or when the remote sensor is directly exposed to sunlight or powerful lighting.
30°