JVC GR-DVL310, GR-DVL815, GR-DVL510 specifications Details, EN71, Power,  pg

DETAILS			EN71
I T E M S	N O T E S
➪ Power	❍ Perform charging where the temperature is between 10°C and 35°C
( pg. 8)	(50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal
	temperature range for charging. If the environment is too cold,
	charging may be incomplete.
	❍ Charging times are for a fully discharged battery pack.
	❍ Charging time varies according to the ambient temperature and the
	status of the battery pack.
	❍ To avoid interference with reception, do not use the AC Adapter
	near a radio.
	❍ Since the AC Adapter processes electricity internally, it becomes
	warm during use. Be sure to use it only in well-ventilated areas.
	❍ The following operation stops charging:
	• Set the Power Switch to “	”, “ ” or “	”.
	• Disconnect the AC adapter from the camcorder.
	• Unplug the AC adapter from the AC outlet.
	• Detach the battery from the camcorder.
➪ VIDEO	❍ When you use the LCD monitor outdoors in direct sunlight, the
RECORDING	LCD monitor may be difficult to see. If this happens, use the
( pg. 16, 17)	viewfinder instead.
	❍ The cassette holder cannot be opened unless a power supply is
	attached.
	❍ There may be a delay after you open the cassette holder cover until
	the cassette holder opens. Do not use force.
	❍ Once the cassette holder is closed, it recedes automatically. Wait
	until it recedes completely before closing the cassette holder cover.
	❍ When the Recording Start/Stop button is pressed, it may take a few
	seconds before actual recording starts. “		” starts rotating when
	the camcorder actually starts recording.
	❍ The time required to calculate and display the remaining tape
	length, and the accuracy of the calculation, may vary according to
	the type of tape used.
	❍ “TAPE END” appears when the tape reaches its end, and the power
	goes off automatically if left in this condition for 5 minutes. “TAPE
	END” also appears when a cassette at its end is loaded.