DETAILS | EN 67 |
|
|
I T E M S | N O T E S |
|
|
➪❍ Perform charging where the temperature is between 10°C and 35°C (50°F
Powerand 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
( pg. 8) | charging. If the environment is too cold, charging may be incomplete. |
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of the battery pack.
❍To avoid interference with reception, do not use the AC Adapter near a radio.
❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in
❍The following operation stops charging:
• Set the Power Switch to “PLAY”, “ | ” or “ | ”. |
AUTO | MANUAL |
|
•Disconnect the AC adapter from the camcorder.
•Unplug the AC adapter from the AC outlet.
•Detach the battery from the camcorder.
➪ TAPE | ❍ When you use the LCD monitor outdoors in direct sunlight, the LCD monitor | |
RECORDING | may be difficult to see. If this happens, use the viewfinder instead. | |
❍ The cassette holder cannot be opened unless a power supply is attached. | ||
( pg. 16, 17) | ||
❍ There may be a delay after you open the cassette holder cover until the | ||
| ||
| cassette holder opens. Do not use force. | |
| ❍ Once the cassette holder is closed, it recedes automatically. Wait until it | |
| recedes completely before closing the cassette holder cover. | |
| ❍ When the Recording Start/Stop button is pressed, it may take a few seconds | |
| before actual recording starts. “ ” starts rotating when the camcorder | |
| actually starts recording. | |
| ❍ The time required to calculate and display the remaining tape length, and the | |
| accuracy of the calculation, may vary according to the type of tape used. | |
| ❍ “TAPE END” appears when the tape reaches its end, and the power goes off | |
| automatically if left in this condition for 5 minutes. “TAPE END” also appears | |
| when a cassette at its end is loaded. |