JVC GR-FXM25 manual To avoid hazard, During use, Store cassettes, For safety, do not

Page 55

CAUTIONS

DANGER:

Video Light

The video light becomes extremely hot. Do not touch it either while in operation or soon after turning it off, otherwise serious injury may result.

Do not place the camcorder into the carrying case immediately after using the video light, since it remains extremely hot for some time.

When operating, keep a distance of about 30 cm between the video light and people or object.

Do not use near flammable or explosive materials.

It is recommended that you consult your nearest JVC dealer for replacing the video light.

General Battery Precautions

When the C-P6U or C-P7U (cassette adapter) is not functioning even when correctly operated, the battery is exhausted. Replace it with a fresh one.

Use only the following battery:

EN55

... store in a cool, dry place. Extended exposure to high temperatures will increase natural discharge and shorten service life.

... avoid prolonged uncharged storage.

... remove from charger or powered unit when not in use, as some machines use current even when switched off.

NOTES:

It is normal for the battery pack to be warm after charging, or after use.

Temperature Range Specifications Charging .............. 10°C to 35°C Operation ............ 0°C to 40°C Storage ................ –10°C to 30°C

Recharging time is based on room temperature of 20°C.

The lower the temperature, the longer recharging takes.

Cassettes

C-P6U or C-P7U

R6 (AA) size

Please make note of the following rules for battery use. When misused, battery can leak or explode.

1.Refer to the C-P6U/C-P7U instructions when replacing the battery.

2.Do not expose the battery to excessive heat as it can leak or explode.

3.Do not dispose of battery in a fire.

4.Remove battery from the unit if it is to be stored for an extended period to avoid battery leakage which can cause malfunctions.

Battery Packs

The battery packs are nickel-cadmium or nickel metal-hydride batteries. Before using the supplied battery pack or an optional battery pack, be sure to read the following cautions:

1. To avoid hazard . . .

... do not burn.

Terminals

... do not short-circuit the terminals.

... do not modify or disassemble.

... use only specified chargers.

2.To prevent damage and prolong service life . . .

... do not subject to unnecessary shock.

... avoid repeated charging without fully discharging.

... charge in an environment where temperatures are within the tolerances shown in the chart below. This is a chemical reaction type battery—cooler temperatures impede chemical reaction, while warmer temperatures can prevent complete charging.

To properly use and store your cassettes, be sure to read the following cautions:

1.During use . . .

... make sure the cassette bears the VHS-C mark.

... be aware that recording onto prerecorded tapes automatically erases the previously recorded video and audio signals.

... make sure the cassette is positioned properly when inserting.

... do not load and unload the cassette repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.

... do not open the front tape cover. This exposes the tape to fingerprints and dust.

2.Store cassettes . . .

... away from heaters or other heat sources.

... out of direct sunlight.

... where they won’t be subject to unnecessary shock or vibration.

... where they won’t be exposed to strong magnetic fields (such as those generated by motors, transformers or magnets).

... vertically, in their original cases.

Main Unit

1.For safety, DO NOT . . .

... open the camcorder’s chassis.

... disassemble or modify the unit.

... short-circuit the terminals of the battery pack. Keep it away from metallic objects when not in use.

... allow inflammables, water or metallic objects to enter the unit.

... remove the battery pack or disconnect the power supply while the power is on.

... leave the battery pack attached when the camcorder is not in use.

Image 55
Contents GR-FXM35 GR-FXM25 It is recommended that you Dear CustomerContents Charging the Battery Pack PowerUsing the Battery Pack Using a CAR Battery Using AC PowerDischarged Getting Started Clock Lithium Battery Insertion/RemovalDate/Time Settings Cont Recording Mode SettingTape Length Setting EN Getting StartedLoading/Unloading a Cassette Viewfinder Adjustment Grip AdjustmentAttach Strap Adjust LengthShoulder Strap Attachment Tripod MountingStart Shooting Power Switch PositionBasic Recording Load a CassettePress Display Button Stop RecordingRecording Shooting While Watching The LCD Monitor Recording Basic RecordingBefore the following steps, perform pg Interface Shooting Journalistic ShootingBrightness Control Zoom Out EN Recording Basic FeaturesPush the Power Zoom Lever towards T ZoomTo check the end of the last recording Feature Quick ReviewPress P. STABILIZER. appears Basic FeaturesFeature Picture Stabilizer Feature 5Sec. Rec 5-sec. Recording GR-FXM25 onlyTo brighten the scene when natural lighting is too dim Feature Video Light GR-FXM35 onlyBattery power If you press during Record-Standby Recording Advanced FeaturesSnapshot GR-FXM35 only Take SnapshotEngagemode FADE- or WIPE-STANDBY Fade/WipeStart or END Recording Press P.AE to cycle through the modes as shown on the left Advanced FeaturesSelect Mode Programme AE With Special EffectsColours of a picture are reversed Display ModeNega Posi mode High shutter speed clearly captures fast-moving actionPress the Select Dial to display the Menu Screen Date/Time InsertSelect the Desired Mode Access Title MenuInstant Titles Make Setting Using Menu For Detailed AdjustmentEND Setting Menu Screen Available Using The Menu Button Menu Screen Available Using The Select DialMenu Screen Explanations Recording pg Tally lamp comes on to signal the start of recordingDemo Mode is set to on and the Menu Screen is closed Allows you to set the current date and time pgEND Adjustment of Exposure Access Exposure MenuAccess Manual Exposure Adjust ExposurePatterns that are regularly repeated FocusingRecording Auto FocusEND Adjustment of Focus Access Focus MenuAccess Manual Focus Adjust FocusTo Return To Automatic White Balance White Balance AdjustmentAccess White Balance Adjustment SET Function ParametersTo Change The Tint For Recording Enter SettingManual White Balance Operation SET Manual White BalanceSET Interval Time Self-TimerAccess INT. Time Menu Start Delayed RecordingTime-Lapse AnimationStop Playback Playback Basic PlaybackRewind or Fast-Forward the tape Play BackTracking Playback FeaturesSpeaker Volume Control Adjust VolumeFeature Counter Memory Function Playback FeaturesFeature Still Playback Feature Shuttle SearchInsert Battery Using The Cassette Adapter EN39Cassette Adapter Connection For Tape Dubbing When connecting the cables, open this coverBasic Connections And Tape Dubbing Basic ConnectionsTape Dubbing Pull OUT Battery Holder Installing The BatteryRemote control uses one lithium battery CR2025 Time-Lapse Feature Self-Timer, Animation and Time-LapseSelf-Timer AnimationOperate VCR Using the Remote Control UnitCreate edited videos easily using your camcorder as SET REMOTE/VCR CodeMake Connections Start Source Playback Select ScenesRegister END of Scene How to use Supplemental Information on the Remote ControlAutomatic Editing to VCR Insert Editing EN Using the Remote Control UnitBegin Audio Dubbing Audio DubbingEND Audio Dubbing Available No power is suppliedRecording does not start Animation or Time-Lapse is notTape will not eject An error number i.e. E03 appearsReview or Retake mode During recording, the indications do not appear52EN DC in Jack Connectors w to r are located beneath the cover Dioptre Adjustment Control Lens Cover Open/Close RingVideo Light Switch Light OFF/AUTO/ON Power Switch Battery Release SwitchIndex Indications Store cassettes For safety, do notTo avoid hazard During useDo not leave the unit Avoid using the unitCleaning The Camcorder To prolong service lifeProvided Accessories Optional Accessories ConnectorsGeneral Memo Memo GR-FXM25