JVC GR-SXM321 specifications 10 EN, Getting Started, Clock Lithium Battery Insertion/Removal

Insert or remove a cassette. When inserting, make sure the label is facing outward.

Press PUSH to close the cassette holder until it locks into place. Close the LCD monitor.

10EN

Slot

GETTINGSTARTED(cont.)

Clock (Lithium) Battery Insertion/Removal

Battery holder

Cassette holder

PUSH Button EJECT Switch

Turn to take up slack.

Erase Protection tab Gear

This battery is necessary for clock operation and to perform date/time settings.

1 Switch off the unit’s power and remove the power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.).

2 Pull out the battery holder to remove it from the camcorder.

3 Insert the battery in the holder, and be sure to have the “+” mark visible.

4 Slide the holder back into the slot until you hear a click.

NOTES:

●See “SAFETY PRECAUTIONS” (☞ pg. 2) for information on safe handling of lithium batteries.

●To avoid losing the battery and/or battery holder, place the camcorder with the grip side up as shown in the illustration when inserting/removing the battery.

Loading/Unloading A Cassette

1 Open the LCD monitor fully.

2 Slide EJECT until the cassette holder opens. Do not use force to open.

3

4

NOTES:

●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor.

●The cassette holder can’t be opened unless a power supply is attached.

●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.

●Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

●The cassette holder cannot be opened while the camcorder is in the record mode.