JVC GR-SXM720 specifications 42 EN, Using the Remote Control Unit, Insert Editing

42EN

USINGTHEREMOTECONTROLUNIT(cont.)

Power Switch

COUNTER R/M Button

Display

w

	Insert editing
	indicator
M– 0 : 1 2 : 3 4	Tape Counter

Remote sensor

Insert Editing

You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V715U remote control unit to perform this procedure.

1 Set the Power Switch to “PLAY”.

2 Play back the tape, locate the Edit-Out point and press PAUSE.

3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press again for less than 1 second so that “M” appears.

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the Edit-In point where the new scene should start.

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

6 To begin Insert Editing, press START/STOP. When the counter reaches “0:00:00”, editing stops automati- cally and the camcorder enters the Insert-Pause mode.

7 To end Insert Editing, press STOP.

NOTES:

PLAY

START/STOP

● During Insert Editing, the original audio will be heard

from the speaker.

● After step 5, Retake (☞ pg. 21) can be performed.

● The tape may stop slightly before or after the designated

end point, and noise bars may appear. Neither indicates

REW

STOPPAUSE INSERT

a defect in the unit.

● Only the video signal is recorded in the Insert Editing

mode.

RM-V715U (provided)