Operation Mode, Data Battery System, Using AC Power

16 EN GETTING STARTED
Data Battery System	Operation Mode
You can check the remaining battery power and	Operation Mode
You can check the remaining battery power and	To turn on the camera, set the power switch to
the recordable time.	To turn on the camera, set the power switch to
1 Make sure the battery is attached.	or	while pressing down the lock button
1 Make sure the battery is attached.	located on the switch.
2 Open the LCD monitor fully.	located on the switch.
2 Open the LCD monitor fully.	● The power/charge lamp turns on.
3 Press INFO/ repeatedly, and the battery	To turn off the camera, set the power switch to
status screen appears.	OFF.
status screen appears.
● It is displayed for approx. 3 seconds if the	1 Power Switch
button is pressed and released quickly, and for	1 Power Switch
button is pressed and released quickly, and for
approx. 15 seconds if the button is pressed			Power/Charge Lamp
and held for several seconds.
● If “COMMUNICATING ERROR” appears
instead of the battery status even though you
tried to press INFO/ several times, there
may be a problem with your battery. In such a
case, consult your nearest JVC dealer.		2 MODE
● The recordable time display should only be		2 MODE	Lock Button
used as a guide. It is displayed in 10 minute	4 LCD Monitor		Lock Button
units.	4 LCD Monitor		3

Using AC Power

Perform step 4 in “Charging the Battery Pack” ( pg. 14).

NOTE:

Set the appropriate operation mode according to your preference using the power and MODE switches and (/) button.

The provided AC adapter features automatic voltage 1 Power Switch Position selection in the AC range from 110 V to 240 V.

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

To resume the original function of the accurate battery power indication

If the battery power indication differs from the actual operating time, fully charge the battery, and then run it down. However this function may not work properly if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.

Set the power switch for recording () or playback () while pressing down the lock button.