JVC GR-FXM555, GR-FXM333 manual Select Scenes, Start Source Playback, Register END of Scene

46EN

USINGTHEREMOTECONTROLUNIT(cont.)

Remote sensor

Power Switch

REW

PLAY

IN/OUT

		RM-V700U
		(provided)
1	IN	OUT
	0:00:25	- - :- - :- -
2
3
4
5
6
7
8		0:00:25
COUNTER
TOTAL		0:00:00
1	IN	OUT
	0:00:25	0:01:05
2	0:03:18	0:03:31
3	0:02:33	0:02:53
4	0:04:11	- - :- - :- -
5
6
7
8		0:04:11
COUNTER
TOTAL		0:01:13

FF PAUSE CANCEL ON/OFF

SELECT SCENES

4 START SOURCE PLAYBACK

Press PLAY, then press ON/OFF on the remote control. Make sure to point the remote control at the camcorder’s remote sensor.

•The R.A. Edit counter display appears.

5 REGISTER BEGINNING OF SCENE Press REW or FF to locate the beginning of the scene you want, then press IN/OUT to register that point.

•The data appears under “IN” on the display.

6 REGISTER END OF SCENE

Press REW or FF to locate the end of the scene and press IN/OUT to register it.

•The data appears under “OUT” on the display. •The total time of the registered scene(s) is displayed

at the bottom of the screen.

7 REGISTER ADDITIONAL SCENES Repeat steps 5 and 6 for each additional scene (as many as 8).

8 MAKE CORRECTIONS (IF NECESSARY) Press CANCEL during steps 5 and 6 to erase the most recently registered point.

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, there should be at least

15 seconds between an out-point and the next in-point.

●Blank portions of a tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing does not take place.

●Pressing ON/OFF clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.

●Turning off the camcorder’s power erases all registered in- and out-points.