JVC GR-AXM22UM manual Load a Cassette, Enter RECORD-STANDBY Mode, Start Shooting, Stop Recording

Page 15

RECORDING Basic Recording

Tape remaining time indicator

25MIN

*---MIN

 

(Now calculating)

 

120MIN

 

119MIN

Power indicator

3MIN

 

2MIN (Blinking)

 

1MIN (Blinking)

 

0MIN (Blinking)

 

LENS COVER

 

Switch

 

DISPLAY button

POWER

 

Start/Stop

 

Tally lamp

NOTES:

EN 15

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

Power (pg. 8)

Tape Length/Recording Mode Setting (pg. 12)

Grip Adjustment (pg. 14)

LOAD A CASSETTE

1 First slide MONITOR OPEN and open the LCD monitor to an angle of over 45 degrees.

Press EJECT to open the cassette holder, then insert the cassette with the label facing out. Press PUSH to ensure the holder is closed and locked.

Shooting while watching the viewfinder

ENTER RECORD–STANDBY MODE

2 Make sure the LCD monitor is closed and locked. Slide the LENS COVER open/close switch to open the lens cover, then set the power switch to

CAMERA.

•The power indicator lights and the camcorder enters the Record–Standby mode.

•The scene you’re aimed at appears on the viewfinder screen, with the word “PAUSE” superimposed upon it.

START SHOOTING

3 Press the Recording Start/Stop button.

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

STOP RECORDING

4 Press the Recording Start/Stop button again to stop recording.

•The camcorder re-enters the Record-Standby mode.

When the power switch is set to CAMERA and the LCD monitor is opened at an angle of 45 degrees or more, the LCD monitor switches on and the viewfinder switches off automatically to save power.

A cassette holder can’t be opened unless a power supply is attached.

There may be a delay after you press EJECT until the holder opens. Do not use force.

The tape’s remaining time is displayed in the LCD monitor or the viewfinder as shown.

The indicated remaining time is approximate.

The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

The tape remaining time indicator is correct only if the correct tape length has been selected (pg. 12).

“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

While shooting, pressing DISPLAY lets you remove some indiations from the screen (pg. 43).

If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations, the camcorder’s power shuts off automatically. Set the Power switch to “POWER OFF”, and then back to “CAMERA” to turn the camcorder on again.

If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5 minutes, recording may not start immediately.

If you’re recording on a cassette from the middle, use the RETAKE function (pg. 19) to find the end of the last recording so you don’t erase any of it.

The LENS COVER warning blinks for about 5 seconds when the camcorder is turned on when the cover is closed.

While shooting, sound is not heard from the speaker.

Image 15
Contents GR-AXM22UM This unit is produced to comply with Standard IEC Publ Dear CustomerInstallation Antenna Installation InstructionsRequirements for the grounding electrode USE ServicingTo avoid personal injury Stop REW BATT. ReleaseEject Push Monitor Open PLAY/PAUSEDC Cord AC Power Adapter Cassette AdapterZoom-in Zoom-outContents Detach Battery Pack PowerSupply Power Attach Battery PackAA-V11EG DC OUTViewfinder Adjustment Start Clock Operation Close MenuNear Menu FAR LCD monitor or viewfinder Recording mode indicator Recording Mode SettingSET Recording Mode Set Power to Camera Tape length indicatorLoading/Unloading a Cassette Grip Adjustment Shoulder Strap AttachmentTripod Mounting Stop Recording Enter RECORD-STANDBY ModeLoad a Cassette Start ShootingBefore the following steps, perform pg Start/Stop Power indicatorJournalistic shooting Self-recordingBrightness control Zooming Zoom-in Zoom-out Zoom indicator Power zoom leverFeature Purpose Operation Push the power zoom lever down toward TFeature Quick ReviewRetake Program AE With Special Effects Darken Image Restore Initial SettingExposure Control Brighten ImageNear FAR FocusingLock Focus Release Focus LockFAR Near Power zoom lever Program AE select dialWide FaderCharacter Generator Instant TitlesSelect Display SELPress SEL. repeatedly until DISP. appears Select White Balance Manual White Balance Adjustment M.W.BAdjust Focus Adjust White BalanceThis camcorder is equipped with an easy-to-use Make SettingDetailed camcorder settings MenuOFF Interval Timer OFFGain UP NormMenu FAR Near Time-Lapse AnimationPlayback Speaker volume controlAdjust Volume Rewind or Fast-forward the tapeFF Stop REW PLAY/PAUSE Counter R/M Feature Connection To a VCR a Editing, Dubbing and PlaybackConnect Camcorder to TV Remove Cassette from Adapter Cassette Adapter VHS PlayPakInsert Cassette in Adapter Play Back on Connected VCRVCR Recording deck Connect to Random Assemble Editing R.A.EditSET Remote to Operate VCR Operate the VCRRegister Beginning of Scene Access R.A. Edit Counter DisplayPrepare Camcorder Prepare VCREdit Begin Automatic EditingEND Automatic Editing Edited Tape VCR StopSet to Power OFF BATT. Release Push EjectRemove Symptom Tape won’t eject Viewfinder Power sourceLens Cover Warning indicator may blink when Lens Cover Warning indicatorTape End Display ................................ pg Focus Indicator44EN Tally Lamp Power On Indicator Power Switch Pg.15 Recording Mode SP/EP SelectCounter R Reset/M Memory Bright Dial Volume DialDiopter Adjust Auto Mode Lock ModeManual Focus MBR Code Setting ND Effect Mode Playback Date/Time SettingTo avoid hazard Using Household AC Plug AdapterTo prevent damage and prolong service life Plug adapterDuring use For safety, do notAvoid using the unit To prolong service lifeLCD system LCD/TFT active matrix System White balance Adjustment Auto/Manual adjustmentOut connector SizeGR-AXM22UM