RIDGID WD14500 Drum/Caster Foot Assembly, Drain, Rear Drum Caster Foot, Front Caster Foot

SP6735-3 RIDGID ES 6/13/12 2:35 PM Page 7

Drum/Caster Foot Assembly

If any parts are missing or damaged contact Customer Service.

Do not assemble until you have all the parts.

1. Insert the front and rear caster feet into	Front
the bottom of drum as shown. Light
taps with a mallet or hammer may be	Caster
	Foot
needed to fully seat both caster feet.
	Drain

Rear

Drum Caster

Foot

2.Install (4) #10 x 1-3/4” screws into matching holes on both front and rear caster feet, securing them to the bottom of the drum. Tighten screws until just snug. Do not over tighten as this may tend to deform the caster feet.

#10 x 1-3/4" Screw (4)

Drain

3.Insert the caster stem into each of the caster feet, as shown.

4.Push on the caster until the ball on the caster stem is inserted all the way into

the socket. You will be able to hear the	Socket
ball snap into the socket and the caster
will swivel easily when positioning is
correct.

Rear

Caster

Foot

Caster Stem Caster Ball

Front

Caster

Foot

7