Smooth Fitness V2300 owner manual Assembly Instructions, Seat and Seat Handlebar Assembly

“ASSEMBLY INSTRUCTIONS”

USE HARDWARE KIT B

STEP 10 – Seat and Seat Handlebar Assembly

a. Locate and secure the Seat Handlebar (11) on the Seat Frame (10) with two Carriage Bolts (M8xp1.25x50mm)(163) and two Nylock Nuts (M8x1.25)(171). NOTE: Be careful not to pinch the Pulse Sensor Wire 4 (184).

b. NOTE: Four Nylock Nuts (M8x1.25)(171) are pre-attached on the Seat Carriage Assembly (9)’s Seat Fixed Stand as the figure shows on the right.

c. Remove four Nylock Nuts (M8x1.25)(171) from the Seat Fixed Stand and set aside for the following assembly process.

d.Attach the Seat Frame (10) to the Seat Carriage Assembly (9)’s Seat Fixed Stand and secure with four Nylock

Nuts (M8x1.25)(171).

NOTE: After assembling the Seat Frame, gently shake the Seat Frame to test and make sure the Seat Frame is firmly secured

e.Place the Seat (56) on the Seat Frame (10) and secure with four Bolts, Socket Head (M8xp1.25x40mm)(161).

f.Attach the Back Cushion (57) to the Seat Frame (10) and secure with two Bolt, Button Head (M8xp1.25x40mm)(155), two Nylock Nut (M8x1.25)(171) and two Screw Caps (58).

g.Follow FIG.2 to plug the Pulse Sensor Wire 4 (184) into the connector A located on the left side of the Seat Carriage Assembly (9) NOTE: Be careful not to pinch the Pulse Sensor Wire 4 (184).

**Make sure the above parts are tightened before moving on to the next page**

11