Maintenance
Filter
!WARNING: To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter.
Your 14 Gallon Professional Wet/Dry Vac is supplied with RIDGID’s VF5000 Fine Dust Filter. Replacement VF5000 Fine Dust Filters are available where you purchased your Vac. Ask for the RIDGID VF5000 Fine Dust Filter.
NOTE: The filter is made of high quality paper designed to stop very small particles of dust. The filter can be used for dry pick up or small amounts of liquid. Handle the filter carefully when removing to clean or installing it. Creases in the filter pleats may occur from installation but will not affect the performance of the filter.
Filter Removal
Refer to page 6 "Filter Removal and Installation" Section of this manual.
!WARNING: Do not operate without filter cage and float, as they prevent liquid from entering the impeller and damaging the motor.
IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the filter before using the Vac for dry material
Cleaning A Dry Filter
NOTE: For best cleaning results due to accumulated dust, clean the filter in an open area. Cleaning SHOULD be done outdoors and not in the living quarters.
1.Remove filter from Vac. Gently tap filter against the inside wall of your dust drum. The debris will loosen and fall.
2.For thorough cleaning of dry filter with fine dust (no debris), run water through it as described under "Cleaning A Wet Filter".
Cleaning A Wet Filter
After filter is removed, run water through the filter from a hose or spigot. Take care that water pressure from the hose is not strong enough to damage filter.
IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it. Even a small hole can cause a lot of dust to come out of your Vac. If your filter is damaged or worn, replace it immediately.
Allow the filter to dry before reinstalling and storing the Vac.
13
