Tape remaining time indicator
25MIN MIN
(Now calculating)
120MIN
119MIN
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
0MIN
(Blinking)
Recording Start/Stop Button
DISPLAY Button
EN17
4 |
| STOP RECORDING |
|
| |
| Press the Recording Start/Stop Button again to stop |
| |||
|
| recording. |
| ||
|
|
|
|
| |
|
| •The camcorder |
| ||
NOTES: |
| ||||
● The cassette holder cannot be opened unless a power |
| ||||
supply is attached. |
| ||||
● There may be a delay after you slide EJECT until the |
| ||||
holder opens. Do not use force. |
| ||||
● The tape remaining time is only displayed in the |
| ||||
viewfinder as shown. |
| ||||
● The remaining time indicated in the viewfinder is |
| ||||
approximate. |
| ||||
● The time required to calculate the remaining tape |
| ||||
length, and the accuracy of the calculation, may vary |
| ||||
RECORDING | |||||
according to the type of tape used. | |||||
● The tape remaining time indicator is correct only if the |
| ||||
correct tape length has been selected (☞ pg. 12). |
| ||||
● “TAPE END” appears when the tape reaches its end, and |
| ||||
the power goes off automatically if left in this condition |
| ||||
for 5 minutes. “TAPE END” also appears when a cassette |
| ||||
whose tape is already at its end is loaded. |
| ||||
● If the |
| ||||
without performing Zoom or any other operations, the |
| ||||
camcorder’s power shuts off automatically. Set the |
| ||||
Power Switch to “POWER OFF”, and then back to |
| ||||
“CAMERA” to turn the camcorder on again. |
| ||||
● If the Recording Start/Stop button is pressed after the |
| ||||
| |||||
5 minutes, recording may not start immediately. |
| ||||
● If you are recording on a cassette from the middle (such |
| ||||
as when a tape is removed and |
| ||||
recording), use the Retake function (☞ pg. 19) to find |
| ||||
the end of the last recording so you don’t erase any of it. |
| ||||
● The LENS COVER warning blinks for about 5 seconds |
| ||||
when the camcorder is turned on with the cover closed. |
| ||||
● While shooting, sound is not heard from the speaker. |
| ||||
● To turn the tally lamp off during recording, refer to pgs. |
| ||||
26 and 28. |
| ||||
Viewfinder Indications |
| ||||
By pressing DISPLAY, you can make the following, indica- |
| ||||
tions appear/disappear from the camcorder’s display: cassette |
| ||||
warning, tape remaining time, battery pack remaining |
| ||||
power indicator and tape length indicator (☞ pg. 45). |
| ||||
|
|
|
|
| |
1 |
| PRESS DISPLAY BUTTON |
| ||
| When you do not want the indications to appear, |
| |||
|
| press DISPLAY for longer than approximately 1 |
| ||
|
| second. Certain indications disappear. |
| ||
|
| Press again for longer than approx. 1 second to make |
| ||
|
| the indications reappear. |
| ||
NOTE: |
| ||||
Even if DISPLAY is pressed, the tape remaining time |
| ||||
appears blinking when the tape is about to reach its end, |
| ||||
and the battery pack remaining power indicator also |
| ||||
appears blinking when the power is almost gone. |
|