JVC LYT0087-001B manual C. Playback Connection, Connect to Personal Computer, END Transferring

D.S.C.PLAYBACKConnection

EN59

Connection to a Windows® PC/Macintosh®

Image data stored in the camcorder's built-in memory can be transferred to a Windows® PC or Macintosh® and saved using the provided image transfer software. The image data transferred to a personal computer can also be further processed using Paint Software, and the still image processed on the PC can be inserted onto a tape (☞ pg. 67).

Set to “D.S.C.”

For Macintosh®: To Modem Port or Printer Port

To DIGITAL jack (8-pin)

PC connection cables (provided)

For Windows®: To COM Port (RS-232C)

CONNECT TO PERSONAL

COMPUTER

1 Connect the camcorder’s DIGITAL jack to the COM Port (RS-232C) on a Windows PC or to the Modem Port/Printer Port (8-pin) on a Macintosh, using the provided PC connection cable.

SELECT MODE

2 Set the System Select Switch to “D.S.C.”, then set the Power Switch to “PLAY”.

•A still image stored in memory appears. •When transferring still images to a computer, be

sure that a still image is displayed on the screen.

RUN IMAGE TRANSFER SOFT- WARE

3 Launch the provided software on your Windows® PC or Macintosh®. Transfer the still images stored in the camcorder’s memory to the Windows® PC or Macintosh®. Refer to the software’s instruction manual on the provided CD-ROM for details.

•During transfer of the still image, the camcorder’s screen becomes blue and “PCMODE” is dis- played. After transferring is finished, the screen displays the same still image as in step 2.

Viewfinder

PCMODE

NOTES:

END TRANSFERRING

4 Close the software, then switch off the camcorder.

●Before transferring still images from your personal computer to the camcorder’s built-in memory, perform the camcorder’s Picture Mode Setting (☞ pg. 45). The still images will be transferred from the personal computer in the selected Picture Mode.

●When transferring still images from your personal computer to the camcorder, make sure the number of images to be transferred is smaller than the camcorder's remaining number of shots available.

●Use the AC Power Adapter/Charger as the power supply instead of the battery pack.

●The still images stored in the camcorder’s memory are not automatically removed after being transferred to the PC. If you wish to remove those still images from the camcorder's memory, delete them (☞ pg. 56, 57).

●Windows® are trademarks of Microsoft Corporation, registered in the U.S.A. and other countries.

●Macintosh® are trademarks of Apple Computer Inc., registered in the U.S.A. and other countries.