JVC LYT0002-073A To AC outlet, Dc Out, Terminal To DC in jack AC Power Adapter/Charger, AA-V11EG

Page 5

EN 5

NOTES:

●The recording time per charge is affected by such factors as the time spent in Record/Standby mode and the frequency of zooming. It is safer to have spare battery packs.

●Charging times noted on page 4 are for fully discharged battey pack, and discharging times are for fully charged battery pack.

●Charging and discharging times vary according to the ambient temperature and the status of the battery pack.

●Remember to set the charge marker after charging a battery pack or after detaching a discharged one from your camcorder.

●Perform the REFRESH function after no less than 5 chargings.

●High temperatures can damage the battery pack, so use only where good ventilation is available. Don’t allow it to discharge in container, such as a bag.

●If you stop recharging or discharging part way through, make sure to remove the battery pack before unplugging the adapter’s AC cord.

●Remove the battery pack from the adapter immediately after discharging.

●To avoid interference with reception, do not use the AC Power Adapter/Charger near a radio.

●Make sure you unplug the DC cord before charging or discharging the battery pack.

●A blinking CHG. indicator means that the battery pack has become hot. Wait until it cools down to continue.

●The CHG. indicator may not light properly with a brand new battery pack, or with one that’s been stored for an extended period. In this case, remove and reattach the battery pack and recharge it. The CHG. indicator should light during recharging. If not, contact your nearest JVC dealer.

To AC outlet

DC OUT

terminal

To DC in jack

AC Power

Adapter/Charger

AA-V11EG

DC cord

To car’s cigarette lighter socket

Car Battery Charger/Adapter

BH-V3E (optional)

USING A CAR BATTERY

Use the optional Car Battery Charger/Adapter (connect as shown in the above illustration).

USING AC POWER

Use the AC Power Adapter (connect as shown in the above illustration).

NOTES:

●When using the car battery, leave the engine idling.

●The optional Car Battery Charger (BH-V3E) can also be used to charge the battery pack.

●When using the optional Car Battery Charger or Car Battery Cord (AP-V7E), refer to the respective instruction booklet.

NOTE:

The supplied AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to 240 V.

Image 5

Contents GR-AX470 shown EnglishThis unit is produced to comply with Standard IEC Publ Dear CustomerMajor Features Supply Power PowerAttach Battery Pack Detach Battery PackCar Battery Charger/Adapter BH-V3E optional Terminal To DC in jack AC Power Adapter/ChargerTo AC outlet DC OUTViewfinder Adjustment Close Menu Start Clock OperationMenu Program AE select dialLoading/Unloading a Cassette Tape Length SettingRecording Mode Setting Tripod Mounting Grip AdjustmentShoulder Strap Attachment Load a Cassette Enter RECORD-STANDBY ModeStart Shooting Stop RecordingFeature Purpose Operation Power zoom switch Zoom-in Zoom-out Zoom indicatorPush the switch up toward W ZoomingRetake Retake R/F FeatureQuick Review SET Video Light Video Light GR-AX470 onlyLight ON/AUTO/OFF JVC dealer for replacing the video lightIndication Viewfinder ModeDial Viewfinder Mode Exposure Control Restore Initial SettingBrighten Image Darken ImageLock Focus FocusingRelease Focus Lock FAR NearPower zoom lever Wide FaderCharacter Generator Instant TitlesSelect Display Choose Display ModeDate/Time Character Insert Adjust White Balance Adjust FocusSelect White Balance Select SETMake Setting Using Menu For Detailed AdjustmentSetting procedure depends on the function you select Press MENU. The normal screen reappearsGain UP Interval Timer OFFNorm OFFMenu + FAR Interval Timer Indicator Rec Time IndicatorTime-Lapse AnimationInsert Cassette in Adapter Cassette AdapterPlay Back on Connected VCR Remove Cassette from AdapterTo Audio Video in connectors To Audio and Video connectorsConnect Camcorder to VCR Connect Camcorder to TVRewind or Fast-forward the tape PLAY/PAUSE REW FF Stop PowerPlayback Stop PlaybackCounter R/M PLAY/PAUSE Stop REW FF Feature Connector, use Connectors Provided Cable adapter Power switchSET Remote to Operate VCR Random Assemble Editing R.A.EditOperate the VCR Connect toPrepare Camcorder Access R.A. Edit Counter DisplayPrepare VCR Register Beginning of SceneEdited Tape VCR Stop Begin Automatic EditingEND Automatic Editing Pull OUT Battery Holder Installing The BatteryReplace Battery Holder Buttons FunctionsSTART/STOP Viss INT. Time REC Time Interval Timer IndicatorTransmitted beam effective area START/STOP REW Pause Insert Play Insert editing indicator ViewfinderCounter R/M Mike Audio dubbing indicatorDUB Pause PlayRecording does not start Recording cannot be performedTape is running, but there’s no playback picture Noise bars appear in the playback pictureTape won’t eject Review or Retake modeShooting a very bright object Image is out of focus40EN Microphone Camera sensorSet to any position other than Auto Lock Focus Indicator# Instant Title Display $ Date/Time Character Display For inserting or replacing the clockDo not burn Store in a cool, dry place. Extended exposureDo not modify or disassemble Use only specified chargers Make sure the cassette bears the VHS-C markClean Lens Clean ExteriorClean Viewfinder Remove EyepieceControlled Dimensions X 42 H Weight Approx g Detection, timerDimensions 188 25 H 104 Weight Approx g Accessory Output Vp-p, 75 ohms Unbalanced via Video Out connectorMEM O Memo GR-AX270