MasterPage: Left 
36 EN EDITING
Dubbing To A Video Unit Equipped
With A DV Connector (Digital
Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
To DV OUT
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
3 Start playback on the camcorder. ( pg. 20)
4 At the point you want to start dubbing, start recording on the video unit. (Refer to the video unit’s instruction manual.)
5 To stop dubbing, stop recording on the video unit, then stop playback on this camcorder.
NOTES:
●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 13)
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again.
●When using a DV cable, be sure to use the optional JVC
Core filter 
DV cable (optional)
To DV IN
Video unit equipped with DV connector