00355A(01)
CAMERA MENU Organization
SYNC
Select INT when using the interal synchronization. LINE... is necessary when syn- chronizing the camera phases to operate multiple cameras by using the external signal (AC signal
➼ CTRL TYPE
This function is not used on the
➼ RS485
Select the Baud Rate (4800, 9600, 19200, or 38400 bps) and Camera Address (0~255) for RS485 communication. When using a multiple number of cameras, each must use a different address. (If the same address is used, communica-
E | You can adjust the PHASE to eliminate any phase deviation between each CAM- |
tion may not be possible.)
E
ERA set. |
CAMERA ID | OFF... |
|
| (LINE LOCK) | |||
IRIS | ALC... |
|
|
|
| ||
AUTO FOCUS | AF |
|
|
|
| ||
SHUTTER | AUTO X8 |
|
|
|
| ||
MOTION | F.FAST |
|
|
|
| ||
WHITE BAL | ATW | When you press |
|
| |||
SYNC |
| LINE... |
|
| |||
| the [ENTER] key |
|
| ||||
SPECIAL | ... | PHASE | (000) | ||||
|
| ||||||
MOTION DET | OFF |
|
| RET |
| ||
EXIT | QUIT |
|
|
|
| ||
You can use this function when using the AC power.
With the DC voltage, you will not be able to set the SYNC with
Position the cursor on the SYNC and use the [LEFT/RIGHT] keys to select the desired sychronization from INT/LINE... When you select LINE... and press the [ENTER] key, a submenu screen where you can adjust the PHASE will appear.
You can adjust the PHASE for NTSC from
SPECIAL
In the SPECIAL menu, you can directly control the POSI/NEGA, PIP, MIRROR, horizontal sharpness, and vertical sharpness.
➼PRESET
You can select and store the desired ZOOM and FOCUS positions from 0 to 9.
➼D-ZOOM
Sets the magnification of the Digital Zoom. Magnification can be set between 2x and 10x in 5 step increments.
➼PIP
Picture In Picture function. Shows a 1/16 screen only when operating the Digital Zoom. If the
➼MIRROR
Horizontally flips the video output signal.
➼POSI/NEGA
Outputs the video output signal normally or inversely.
➼ZOOM SPEED
Sets the Zoom speed. Pressing the [LEFT, RIGHT] keys in the ZOOM SPEED menu will change the zoom speed as follows:
1 : Takes about 14 seconds from 1x to x12 Slowest speed
2 : Takes about 6 seconds from 1x to x12 Slow speed
3 : Takes about 4 seconds from 1x to x12 Fast speed
4 : Takes about 2 seconds from 1x to x12 Fastest speed
➼DETAIL
Adjusts the horizontal and vertical sharpness.
If you select ON and press the [ENTER] key, a “SPECIAL” submenu screen where you can set special functions will be displayed.
34 | 35 |