Safety cautions
WARNING!
Only a qualified building contractor shall install or uninstall this unit.
Improper installation may cause the unit to fall, resulting in injury.
To prevent injury, the unit must be securely attached to the wall in accordance with the installation instructions.
Do not install the unit where it cannot support the load.
If the mounting parts are not strong enough, this may cause the unit to fall, resulting in injury.
Do not use installation methods other than instructed. This may cause the unit to fall and be damaged, resulting in injury.
Do not install the unit at locations other than vertical walls.
This may cause the unit to fall and be damaged, resulting in injury.
Take the safety factor for mounting strength into account (approx. 10 times the product weight).
Insufficient strength will cause the unit to fall, resulting in injury.
The wall on which the unit is to be attached to should be capable of supporting 5 kg (11.1 lb.) per screw. Insufficient strength of the walls will cause the unit to fall in the long run.
Do not disassemble or modify the
CAUTION!
Do not install this unit at humid or dusty locations, or locations where airborne grease or steam may come into contact with the unit, or under an air conditioner where water may drip onto the unit.
This may have negative impact on the unit, resulting in fire or electric shock.
Secure enough space of more than 25.4 mm (1") above the main unit and more than 25.4 mm (1") on the left and right sides respectively. Keep space between the wall and rear of the unit clear of obstructions.
Blocking the exhaust holes on the main unit may result in fire.
Use the designated components for installation.
Otherwise, the main unit may fall and be damaged, resulting in injury.
Prevent the mounting screws or power cord from coming into contact with metal parts inside the wall during installation.
Failure to do so may cause electric shock.
When removing the main unit, remove the wall mounting screws as well.
Otherwise the wall mounting screws may hit a person and lead to injury.
Install the unit at a height where the SD card slot can be seen for safe operation.
Operating at improper position may cause the unit to fall and be damaged, resulting in injury.
Product Service
1.Damage requiring service — The unit should be serviced by qualified service personnel if:
(a)The AC Adaptor has been damaged; or
(b)Objects or liquids have gotten into the unit; or
(c)The unit has been exposed to rain; or
(d)The unit does not operate normally or exhibits a marked change in performance; or
(e)The unit has been dropped or the cabinet damaged.
2.Servicing — Do not attempt to service the unit beyond that described in these operating instructions. Refer all other servicing to authorized servicing personnel.
3.Replacement parts — When parts need replacing ensure the servicer uses parts specified by the manufacturer or parts that have the same characteristics as the original parts. Unauthorized substitutes may result in fire, electric shock, or other hazards.
4.Safety check — After repairs or service, ask the servicer to perform safety checks to confirm that the unit is in proper working condition.
The servicer will require all components to service your system.
Therefore, should service ever be necessary, be sure to bring the entire system.
Product information
For product information or assistance with product operation:
Refer to “Customer Services Directory (United States and Puerto Rico)” on page 27.
and wipe it using a soft and dry cloth. | Reference | |
Maintenance |
| |
Unplug the AC adaptor from the household AC outlet |
| |
• When the dirt is heavy, wring water out of a wet cloth to |
| |
wipe the dirt and then wipe with a dry cloth. |
| |
• Do not use solvents including benzine, thinner, alcohol, |
| |
kitchen detergent, etc. This might cause the exterior case | ServiceProduct Maintenance | |
to be deformed or the coating to come off. | ||
| ||
• Before using chemically treated cloth, read the instructions |
| |
that come with the cloth carefully. |
| |
| Using in a | |
| VQT2Z87 |
25