Panasonic DMC-FS16, DMC-FS14, DMC-FS18, DMC-FS35 operating instructions  Important

Page 3

Caution for AC mains lead

For your safety, please read the following text carefully.

This appliance is supplied with a moulded three pin mains plug for your safety and convenience.

A 5-ampere fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5-ampere and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a replacement cover is obtained.

A replacement fuse cover can be purchased from your local dealer.

CAUTION!

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13- AMPERE SOCKET.

If a new plug is to be fitted please observe the wiring code as stated below. If in any doubt please consult a qualified electrician.

IMPORTANT

The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral, Brown: Live.

As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black or Blue. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Brown or Red.

WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER E, BY THE EARTH SYMBOL OR

COLOURED GREEN OR GREEN/YELLOW.

THIS PLUG IS NOT WATERPROOF- KEEP DRY.

Before use

Remove the connector cover.

How to replace the fuse

The location of the fuse differ according to the type of AC mains plug (figures A and B). Confirm the AC mains plug fitted and follow the instructions below.

Illustrations may differ from actual AC mains plug.

1. Open the fuse cover with a screwdriver.

Figure A

Figure B

Fuse cover

2.Replace the fuse and close or attach the fuse cover.

Figure A

Figure B

 

Fuse

Fuse

(5 ampere)

(5 ampere)

 

(ENG) VQT3D41 3

Image 3
Contents DMC-FS18 DMC-FS16 DMC-FS14 Product identification marking Information for Your SafetyDear Customer Carefully observe copyright laws Important About the battery pack About the battery charger For business users in the European Union Contents Indicated as battery charger or charger in the text AccessoriesSales and Support Information Optional AccessoriesNames of the Components Or Press 1617 About batteries that you can use with this unit Charging the BatteryCharging time Charge indicator turns offWhen the Charge indicator flashes Supplied battery Optional batteryDMC-FS35 Supplied battery Optional battery DMC-FS18Recording conditions by Cipa standard About the Built-in Memory/the Card Built-in MemoryCard Slide the card/battery door to open it Inserting and Removing the Card optional/the BatteryDMC-FS18 DMC-FS16 DMC-FS14 Clock is not set when the camera is shipped Setting Date/Time Clock SetList of Rec Modes Selecting the Rec ModeFunction ñ Intelligent Auto Mode Taking pictures using the automaticScene Detection Press the shutter button fully to stop recording Motion Picture ModeOnce deleted, pictures cannot be recovered Playing Back Pictures Normal PlayDeleting Pictures Setting the Menu Close the menuPress several times or press the shutter button halfway For Windows For Macintosh Specifications Burst recording Burst speed Metering modeFocus range Shutter systemMicrophone DimensionsLCD monitor Flash rangeMass Temperature Operating humidityBattery Charger Panasonic DE-A92A Battery Pack lithium-ion Panasonic NCA-YN101HPanasonic Corporation