Panasonic SDR-H20GN, SDR-H250GN operating instructions About recovery

Page 92

LSQT1214_GN.book 92 ページ２００７年２月８日木曜日午後８時５０分

Others

	CHANGE TO MANUAL
	MODE.
	CANCEL NIGHT VIEW	You are attempting to use a function that cannot be used
	MODE.	simultaneously.
	TURN OFF THE VIDEO
	LIGHT.
	OPERATION FAILED.
	EXCESSIVE SHOCK	The unit has detected that it is being dropped so the operation has
	DETECTED. PLEASE TRY	stopped.
	AGAIN AFTER A WHILE.
	INTERNAL TEMPERATURE	The internal temperature of this unit is high so it cannot be operated.
	TOO HIGH. PLEASE TURN
	TOO HIGH. PLEASE TURN	Turn off the power, wait until the temperature falls and then turn on
	UNIT OFF AND WAIT A
	UNIT OFF AND WAIT A	the power again.
	WHILE.	the power again.
	WHILE.
	OPERATION STOPPED.	The internal temperature of this unit is extremely low so it cannot be
	OPERATION STOPPED.	operated.
	TEMPERATURE TOO LOW.	If “Please Wait.” appears after this message, wait a while without
		turning the unit off. It may take time until the unit can be used.
	PUSH THE RESET	An irregularity in the unit has been detected. Remove the SD card
	SWITCH.	then press the RESET button to restart the unit. (l 99)
	DISCONNECT USB	The unit cannot correctly establish the connection to the computer
	DISCONNECT USB	or printer. Disconnect and reconnect the USB cable and then select
	CABLE.
	CABLE.	the desired USB function again.
		the desired USB function again.
	CANNOT OPERATE WHILE	The unit’s power cannot be turned off when the unit is connected to
	USB CONNECTED.	the computer.

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is turned off for some reason during recording or editing.

If faulty management information is found when the HDD or a card is accessed, one of the following messages may appear. Be sure to follow the messages. (Repairing may take time depending on the error.)

HDD ERROR DETECTED. NOW REPAIRING DATA.

CARD ERROR DETECTED. NOW REPAIRING DATA.

≥When you repair the data, use a battery with sufficient battery power or the AC adaptor. Even if the power is turned off without repairing the data, you can repair the data when you turn the power on again.

≥Depending on the condition of the data, it may not be possible to completely repair the data.

≥Do not repair a card that has been recorded on another device. This may cause the loss of data or the card.

92

LSQT1214

Image 92

Contents SDR-H20GN Information for Your Safety Use only the recommended accessoriesIndemnity concerning recording content Carefully observe copyright lawsContents Dubbing images Creating DVD-Video discs101 104Features Before usingExtended recording Easy recording! l34Using with a computer! l Editing scenes! l59Accessories Optional accessoriesParts identification and handling Lens Leica Dicomar SDR-H250 Lens SDR-H20Card slot cover SD Card l Card access lamp Access l 17 Using grip belt Adjust the belt length and the pad positionUsing the lens cover SDR-H250 Before using Grip belt lUsing the LCD monitor Adjust the angle of the LCD monitor as desiredTripod receptacle During recordingConcerning the button-type battery Using the remote control SDR-H250Install a button-type battery Remote control usable range HDD and SD card Concerning SD cardsDisplay on Screen Indication in these Instructions CapacityHandling precautions 256 MBHDD handling precautions Access lampCard access lamp Power supply Charging the batterySetup Charging lamp Lights up ChargingCharging time and recordable time Charging timeSDR-H250 SDR-H20Setup SDR-H20 Connecting to the AC outlet How to turn on the power Set the OFF/ON switch to onHow to turn off the power Set the OFF/ON switch to OFF How to turn the power on and off with the LCD monitorTo turn on the power Open the LCD monitor To turn off the power Close the LCD monitorSet the OFF/ON switch to OFF to turn off the power Inserting/removing an SD cardSelecting a mode How to use the joystickSecurely close the card slot cover Basic operationsMove the joystick up, down, left or right to operate About the operation icons displayed in each mode Video recording modeSetup Picture recording mode Picture playback modeSwitching the language Using the menu screenOperating with remote control SDR-H250 Press the Menu buttonTo get back to the previous screen To exit the menu screenPress the Menu button to exit the menu screen Setting date and timeSelect a menu item Adjusting the LCD monitor Setup Display style Screen displayPower LCD Plus Recording Before recordingBasic camera positioning About auto mode Anti-Ground-Shooting AGS SDR-H250Recording motion pictures Screen indications in the video recording mode Recording modeTo end the recording Recording time elapsedHDD SD cardRecording still pictures Press the Photoshot button fully to take the picture SDR-H20 To record still pictures clearlyScreen indications in picture recording mode Concerning the focusing area SDR-H250Recording with a shutter operation effect Size of still pictures Selected recording destinationPicture Size Zoom in/out function Move the zoom leverDigital zoom function SideRecording yourself Recording with the video light SDR-H250To use the zoom microphone function Rotate the LCD monitor towards the lens sideBacklight compensation function Fade in/fade out functionMove the joystick up to select ª To return to normal recordingPress the recording start/stop button Soft skin modeMove the joystick left to select To cancel the tele macro function Tele macro function SDR-H250Colour night view function Move the joystick up to selectSelf-timer recording Recording guideline functionMove the joystick left to select Ø Press the Photoshot buttonWide mode Image stabilizer functionWind noise reduction function Recording images with a 169 aspect ratioTo cancel the scene mode function Scene modeTo cancel the wind noise reduction function White balance Manual focus adjustmentTo restore to the automatic adjustment Set the AUTO/MANUAL/FOCUS switch to Manual About the black balance adjustment SDR-H250Manual adjustment mode About the white balance sensor aTo restore to automatic adjustment Manual shutter speed/ aperture adjustmentMove the joystick left or right to make the adjustment Manual shutter speed adjustment Manual iris/gain adjustmentMotion picture playback Select the scene to be played backPress the joystick Move the joystick to operateTo display the recording date during playback To adjust the volume Move the volume lever to change the volume levelFrame-by-frame playback Playing back motion pictures by dateScenes recorded on the same day are displayed as thumbnails Still picture playback Select the file to be played backSelected medium File number About still picture compatibilityLSQT1214GN.book 58 ページ２００７年２月８日木曜日午後８時５０分 Editing scenes Deleting scenesDeleting scenes one at a time Select the scene to be deleted, then press the joystickUsing playlists What is a playlist?Locking motion picture scenes Select the scene to be protected, then press the joystickTo play back a playlist Creating a new playlistTo add another scene to the same playlist Playing back a playlist Editing a playlistSelect the scene to start playback, then press the joystick Adding scenes to playlistMoving scenes Select the scene to be moved, then press the joystickDeleting scenes Press the button in the thumbnail displayDeleting files one at a time Editing still picturesDeleting still picture files To continue deleting other files Locking still picture filesSelect the file to be deleted, then press the joystick Dpof setting To cancel all Dpof settingsWhat is DPOF? Select the file to be protected, then press the joystickTo cancel copying halfway Copying still picture filesSelect Select or ALL and press the joystick Select the file to be copied, then press the joystickHDD management Card managementFormatting HDD Displaying HDD informationLSQT1214GN.book 69 ページ２００７年２月８日木曜日午後８時５０分 With a TV Playback on TVConnect this unit and a TV Start playback on this unitWith a DVD recorder With a VCRDubbing recordings onto a DVD recorder Dubbing images onto other video devicesWith a printer PictBridge Connect this unit and a video deviceConnect this unit and a printer Select PictBridge # HDD or SD Card and press the joystickSelect the date print setting on Date Print Select the paper size setting on Paper SizeSelect the layout setting on page Layout Select a file to be printed, then press the joystickLSQT1214GN.book 74 ページ２００７年２月８日木曜日午後８時５０分 With a computer Before using with a computerWhat you can do with a computer Operating environment ImageMixer3 for PanasonicDisc type Using Built-in SD DriveUsable discs Insert the CD-ROM into the computer InstallationInstalling ImageMixer3 for Panasonic Software uninstallation Connection and recognition proceduresConnection and recognition Reading the software helpAbout the computer display Connect this unit and a computerSelect PC Connect # HDD or SD Card and press the joystick Drive iconsRotate the mode dial to select or Press the DVD Copy button To disconnect USB cable safelyDVD Copy function Double click the icon in task trayPlaying back and importing images Insert a DVD disc into the DVD driveClick the desired scene and click Playback a Click the desired scene and click Import BCreating DVD-Video discs with the selected images Check the write settings and click OK To import still picturesInsert a DVD disc into the DVD drive and click Write tab Click Still image DMenus Menu listMotion picture recording menus Still picture recording menusDelete ALL l 64 Select l Other menusStill picture playback menus Beep BeepsBeeps for 4 times FlashIndications IndicationsMedia indications Recording indicationsNo.10 Playback indicationsConfirmatory indications LIMIT. Backup HDD then Format Recommend Data Back MessagesAbout recovery Functions that cannot be used simultaneously Frequently asked questions What should I do when the HDD is full?What kind of cards can be used on this unit? Can motion pictures be recorded on an SD card?Is playback possible on a computer? Is editing possible on a computer?Troubleshooting ≥ Is the memory of the HDD or card full? Playback pictureStops # Do not drop or shake this unit while operating it Recording stops≥ Is manual focus mode selected? Recorded still picturesAre not clear This unitCard then press the Reset button to restart the unit # SDR-H250 Press the Reset button with the projecting partSWITCH. is displayed ≥ Is this unit connected to a computer?Others With a computer Even if connected byReconnect the USB cable An image that should CD-ROM to your computer. l Will not start even whenWhen carrying the unit, do not drop or bump it About this unitAbout the SD card About the batteryAbout the AC adaptor LCD monitor About condensationCauses of condensation What to do if the lens is fogged upExplanation of terms Automatic white balanceWhite balance Auto focusSD Speed Class Rating Class Recording a subject with little contrastSpecifications SD Card/Hard Disk Video CameraDimensions Operating temperatureOthers Video output level Audio output level LineOthers Still pictures Picture sizeNumber of recordable PicturesNumber of recordable pictures on the HDD or an SD card 30 GB16 MB 32 MB 64 MB 128 MB 512 MBOthers SDR-H20 Picture size 640k480 640k360111 LSQT1214 a