Panasonic SV-AV10U operating instructions Erasing the Files Recorded on a Card, To erase All Files

/ MENU			2
			1,3
			3,4
	+
		VOL
	-		1,2

3

1

ERASE CARD FILE

FILE PROTECTION

DPOF SETTING

CHECK

EXIT

2

ERASE FILE

NO RETURN

YES

4	CARD EDITING
	ERASE ALL FILES
		YES
	FILE PROTECTION
		YES
	DPOF SETTING	YES
	SLIDE SHOW	YES
	CARD FORMAT	YES
	PRESS MENU TO RETURN

Erasing the Files Recorded on a Card

Using SD Multi AV Device, you can erase the files recorded on a Card. After the file is erased, it cannot be restored.

1Play back the file to be erased or let it pause. (l 15, 17 ,19)

2Press the [MENU] Button.

≥The editing menu screen appears 1.

≥Except for the still picture mode, [DPOF SETTING] is not displayed.

3Move the Jog Lever up or down to select [ERASE CARD FILE] and press down the center of the Jog Lever 3

≥A verification message appears 2.

4Move the Jog Lever up or down to select [YES] and press down the center of the Jog Lever 3

≥The selected file is erased from the Card.

≥If [NO] is selected, the file selection is cancelled.

≥To abort the [CARD EDITING] screen, select [EXIT].

ªTo erase All Files

1Set [ERASE ALL FILES] on the [CARD EDITING] 4 Menu to [YES].

≥A verification message appears.

2Select [YES].

3Press the [MENU] Button twice.

≥Erased files cannot be restored.

≥This SD Multi AV Device cannot erase any music files (MPEG2-AAC and MP3) (l 20).

≥The files recorded in the Voice Record mode (l 18) are automatically

locked. Release the lock to erase them.

≥Do not erase the Voice Files recorded with this SD Multi AV Device using other devices.

≥A locked file cannot be erased. Release the lock to erase them.

≥No files can be erased if the write protect switch on the SD Memory Card is set to [LOCK].

≥If a file is erased on the SD Multi AV Device, the DPOF information set by another camera may also be erased.

≥A still picture file (other than JPEG) that cannot be played back on the SD Multi AV Device may be erased.

≥Erasing many files may take a little time. Wait until the ACCESS Lamp goes out. (The message [PLEASE WAIT] will be displayed.)

23