Flashing approx. every 1 second (flashes on approx. 0.5 seconds and off approx. 0.5 seconds):
≥The SD Video Camera, battery or AC adaptor may be defective. Contact your nearest Panasonic dealer.
Flashing approx. every 12 seconds
(flashes on approx. 6 seconds and off approx. 6 seconds):
≥The ambient temperature or that of the battery itself is too high or too low. Charging proceeds, but will take a longer time.
Turning off:
Charging is completed.
≥If the Power Lamp turns off when charging is not completed, the AC Adaptor or the battery is probably defective. Contact your nearest Panasonic dealer.
Notes and Hints
ªCharging the Battery (l 10)
≥When the Battery Level Indicator
indicates [ 
], the battery will run out in a few minutes. Recharge the
battery.
≥It takes approx. 145 minutes, maximum for
(77°F (25°C) /60%). If the Battery is charged at a higher or lower temperature, the charging time may be longer.)
≥The capacities of the recording time/ playback time/still picture storage with a supplied,
Number of Recordable Still Pictures |
| |
(PICTURE) |
| |
(When recording still pictures with | 220 still | |
setting the [Picture size] to | ||
pictures | ||
[1600 k 1200] and [Quality] to | ||
| ||
[Normal] every 30 seconds, activating |
| |
flash every other recording.) |
| |
Maximum Continuous Recording Time | 120 min. | |
(MPEG4) |
| |
Maximum Continuous Playback Time | 150 min. | |
(MPEG4) |
| |
Maximum Continuous Voice | 240 min. | |
Recording Time (VOICE) | ||
| ||
Maximum Continuous Music Playback |
| |
Time (AUDIO) | 240 min. | |
(When the [Power save] function is | ||
| ||
activated) |
| |
|
|
The times/number of images listed in the above table are approximate.
≥Be sure to detach the battery after use.
≥If you disconnect the DC Input Lead or the AC Main Lead while charging the Battery, Power Lamp flashes several times and goes off. For continuing Battery charge, wait for approx. 1 minute, and then connect the AC Main Lead and the DC Input Lead.
≥It is recommended to set the battery even when using the AC adaptor.
≥The main unit becomes hot when it is being charged or used. This is normal.
≥When removing the battery, take care not to drop it.
≥When the SD Video Camera is turned on, do not attach or remove the battery, or plug the power cord in or out.
ªInserting a Memory Card (l 11)
≥While the card access lamp is on, the following operations should not be attempted: (Such action will damage the Memory Card, cause loss of recorded data and cause the SD Video Camera to malfunction.)
49