Panasonic SDR-H250EB operating instructions Troubleshooting

LSQT1211(PAL_ENG).book 99 ページ ２００７年２月１３日 火曜日 午後１時１４分

Others

Troubleshooting

Problem	Check points
	≥ Is the battery fully charged?
	# Charge the battery using the AC adaptor. (l 20)
This unit cannot be	≥ The battery protection circuit may have operated. Attach the
turned on.	battery to the AC adaptor for 5 to 10 seconds. If the unit still
	cannot be used, the battery is faulty.
	≥ Is the LCD monitor opened?
	≥ If you do not use the unit for approximately 5 minutes, the
This unit is turned off	power is automatically turned off to conserve the battery
	charge. To resume recording, turn the power back on.
automatically.
	The power will not turn off automatically when the power save
	function (l 90) is set to [OFF].
This unit does not stay	≥ Is the battery low?
	# If the remaining battery power indication is flashing or the
on long enough.	message “LOW BATTERY.” is displayed, the battery has run
	down. Charge the battery. (l 20)
A clicking sound is heard
when the power is turned	≥ This is the sound of the lens moving and is not a malfunction.
off.
	≥ Is the battery fully charged?
	# Charge it with the AC adaptor. (l 20)
	≥ Are you using the battery in an extremely cold place?
Battery runs down	# The battery is affected by ambient temperature. In cold places,
	the operating time of the battery becomes shorter.
quickly.
	≥ Has the battery worn out?
	# The battery has a limited life. If the operating time is still too short
	even after the battery is fully charged, the battery has worn out
	and can no longer be used.
This unit cannot be	≥ The unit cannot be operated unless you open the LCD monitor.
	≥ Remove the SD card then press the RESET button. (l 102) If
operated though it is
	normal conditions are not restored yet, remove the battery or
turned on.
	AC adaptor, wait about 1 minute and then reconnect the
This unit does not	battery or AC adaptor. Then about 1 minute later, turn on the
	power again. (Conducting the above operation when the
operate normally.
	access lamp is on may destroy the data on the HDD or card.)
	≥ Has the demonstration started?
	# If you set [DEMO MODE] to [ON] without inserting a card in
The screen has changed	video recording mode or picture recording mode, the unit is
	automatically set to the demonstration mode for introducing its
suddenly.
	functions. Normally this should be set to [OFF]. Press the MENU
	button, then select [SETUP] # [DEMO MODE] # [OFF] and
	press the joystick.

99

LSQT1211