Power Supply
Charging the Battery Pack (PV-BPN10 or PV-BPN10/1B only)
Install the Battery Pack (see page 8.)
Charge the Battery Pack fully before operation.DC IN
Connector
3
5
POWER CHARGE
Lamp Lamp
2 1 
4
1 Connect DC OUT on the AC Adaptor to DC IN on the Digital Camera Station until it locks with a click.
2 Plug the AC Adaptor into an AC outlet.
The POWER Lamp lights up.
3 Insert the Digital Camera into the Digital Camera Station until it locks.
4 Slide the CHARGE switch.
The CHARGE Lamp lights orange, and then changes to green when charging is done (just under 2.5 hours).
•A red CHARGE Lamp indicates a charge malfunction. Remove the Digital Camera and repeat steps 3 and 4.
If the CHARGE Lamp is still red, send the unit in for service.
5 Slide the RELEASE switch to release the Digital Camera from the Digital Camera Station.
•With a fully charged Battery Pack, you will
have a maximum of about 50 minutes* of continuous playback(77°F/25°C).
* When playback 1 image every 60 seconds.
•The useful operation time of the Battery will gradually decrease after repeated use and recharging. The Battery is no longer serviceable if the operation time is very short, even after a sufficient charge.
•Instead of the supplied Battery Pack, you can also use AA type
•For emergency use you can install 2 Panasonic alkaline batteries. But, due to power consumption and shorter operation life of alkaline batteries compared to the supplied rechargeable battery pack, it is strongly recommended that only the Optical Viewfinder (turn off the LCD Viewfinder) be used to capture images when using alkaline batteries.
•If you are not going to use the Digital Camera for an extended period of time, remove the Battery Pack from the Digital Camera.
CAUTION
Discharge the remaining voltage of the Battery Pack completely before charging. This is vital to maintain battery life and the operation time due to characteristics of the battery.
Do not remove the Digital Camera while charging is in progress.
9