Preparations (continued)
-10W Color Enhancement Light (Supplied)
Using the Color Enhancement Light, you can
provide additional light to brighten the natural colors in a scene.
1 Mount the Light on the Accessory Mount on the Movie.
LIGHT SWITCH LOCK RELEASE BUTTON
\
Replacement of the Lamp Bulb
Danger:
oWhen replacing the bulb use only lamp bulbs
(PART NO. VLLW0002) Supplied by Panasonic to reduce the risk of fire.
Use a cloth or tissue when handling the bulb as finger oils will decrease the bulb life. To prevent possible burn hazard disconnect Movie Light Unit and allow lamp to cool before replacing.
eDo not connect any light other than the standard light included. Use of a different light, modification to the light connector or light jack may cause severe battery drain and fire hazard.
Be sure to mount the Color Enhancement Light until it locks into place.
2 Using the Light switch on your Movie, turn the
Light ON.
CAUTION:
This Light becomes hot during operation.
To release
To remove the Color Enhancement Light from the
Movie, hold down the Lock Release button and slide off the Color Enhancement Light.
1 Turn the screw on the underside of the reflector casing counterclockwise to loosen it.
2 Turn the reflector casing counterclockwise only as far as shown in the diagram and pull it completely off the bulb housing.
3 Pull the old bulb off the base and replace it.
4 Reposition the reflector casing on the bulb housing as in step 2, and turn it clockwise to reattaeh. Replace and tighten the screw.
Note:
tlf using the Enhancement Light for an extended pedod of time, take note of the surrounding temperature, As a safety feature, if the surrounding temperature exceeds 104°F (40"C), the light will temporarily go out, It will resume normal operation when the temperature drops, Be sure to provide ventilation when using the light in a hot environment,
oUsing the Enhancement Light when the Movie is powered by a car battery may shorten bulb life,
14