Panasonic PV-DV702 operating instructions Memory-Stop Editing, Jog Key

4, 5PAUSE

To listen to the desired audio sound, set the AUDIO setting of the VCR mode MENU (Menu OSD: p. 111) as follows:

AUDIO:The following selections are available for 12 bit AUDIO dubbed recordings only (sound recorded in SP mode only).

ST 1	Set this position to listen to the
	original sound.
ST 2	Set this position to listen to the
	audio dubbed sound.
	Set this position to listen to both
MIX	the original sound and the audio
	dubbed sound.

Note

•16 bit dubbed sound completely erases the original 16 bit recorded sound.

•If you dubbed using 12 bit AUDIO recording and then selected AUDIO-MIX in the menu for playback, the sound will be stereo regardless of the AUDIO-OUT setting.

•If you recorded in LP mode, you cannot use the A.DUB feature.

Memory-Stop Editing

You can set an automatic Dubbing stop point.

DRESET

AMENU

Editing Features

4 Press (PAUSE) to start Audio Dubbing. “A.DUB ” indication appears.

•Connect the Palmcorder to the TV in order to monitor the sound.

(p. 39)

Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format.

5 Press (PAUSE) to stop Audio Dubbing.

•If the microphone used for dubbing gets too near the speaker of your TV,

a howling noise (feedback) may occur.

•If the tape position is in or was started in a blank section, you cannot use the A.DUB feature.

						Editing
BRotate JOG KEY to select DISPLAY						Features
APress MENU to display the VCR
menu screen.
		, and then press
	SETTING			JOG KEY
	to display	the DISPLAY SETTING
menu.
CRotate JOG KEY to select					,
			DISPLAY
and then press JOG KEY			to set to
MEMORY.
DPress MENU two times to exit MENU
mode. Then, press RESET on the
remote control to reset the Counter
Memory to M 0:00:00.
Now, rewind to the editing start point,
and continue with steps 2-5. The tape will
now stop automatically at “M 0:00:00”.

45