Panasonic PV-GS250 Charging time and recordable time, Connecting to the AC outlet

Before using

ªConnecting to the AC outlet

1

1Connect the AC cable to the AC adaptor and the AC jack.

2Connect the DC cable to the AC adaptor.

3Connect the DC cable to this product.

≥Lift up the viewfinder beforehand.

≥The output plug of the AC cable is not completely connected to the AC adaptor jack. As shown in 1, there is a gap.

≥Do not use the power cord for other equipment since the power cord is exclusively designed for this Camcorder. Do not use the power cord from other equipment for this Camcorder.

ªFitting the battery

Push the battery against the battery holder and slide it until it clicks.

ªRemoving the battery

While pushing the [PUSH BATT] button, slide the battery (or the DC input lead) to remove it.

PUSH

BATT

≥Hold the battery with your hand so it does not fall.

Charging time and recordable time

The times shown in the table below show the times at a temperature of 68oF (25oC) and a humidity of 60%. This is just a guide. If the temperature is higher or lower than the specified value, the charging time will become longer.

Supplied	A	2 h. 25 min.
battery/	B	2 h. 5 min.
CGA-DU12		(1 h. 55 min.)
(7.2 V/
1150 mAh)
CGA-DU21	A	3 h. 55 min.
(7.2 V/	B	3 h. 30 min.
2040 mAh)		(3 h. 15 min.)
CGR-DU06	A	1 h. 40 min.
(7.2 V/	B	1 h. 5 min.
640 mAh)		(1 h.)

ACharging time

BMaximum continuously recordable time “1h. 10 min.” indicates 1 hour 10 minutes. ≥The battery CGA-DU12 is supplied.

≥The times shown in the table are rough estimates. The times indicate the recordable time when the viewfinder is used. The times in parentheses indicate the recordable time when the LCD monitor is used.

≥We recommend the Battery Pack CGA-DU12 and CGA-DU21 for long recording time (2 hour or more for continuous recording, 1 hour or more for intermittent recording).

≥The recordable time will become shorter in the following cases:

≥When you use both the viewfinder and the LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, 0 Lux MagicPix function, etc.

≥When you use this Camcorder with the LCD monitor lit up by pressing the [POWER LCD] button.

≥When you use accessories fitted on the Camcorder’s smart accessory shoe such as the stereo zoom microphone and video DC light, etc..

≥The batteries heat up after use or charging. The Camcorder being used will also heat up. This is normal.

≥Along with the reduction of the battery capacity, the display will change: r# s# t# u# v. If the battery discharges, then u(v) will flash.

17

LSQT0862