Panasonic PV-GS250 operating instructions Before recording with audio dubbing

Edit mode

5Press the [;] button on the remote control to start audio dubbing.

V/REW PLAY FF/W

W

STILL ADV PAUSE STILL ADV VOL

A.DUB ¥

STOP

≥When the Magic Wire Remote Control with Narration Mic is used, start recording with the [TALK] button pressed.

≥Talk into the microphone. Or start play on the playing device.

6Press the [;] button on the remote control to stop audio dubbing.

V/REW PLAY FF/W

W

STILL ADV PAUSE STILL ADV VOL

STOP

≥If a tape has a non-recorded portion when the tape is dubbed, images and sounds may be disturbed when this portion of the tape is played back.

ªBefore recording with audio dubbing

≥Set to Tape Recording Mode.

≥When you want to preserve the original sound taken during recording, set [SETUP] >> [AUDIO REC] >> [12bit] to take pictures. (When set [16bit], the sounds taken during recording are erased after recording with audio dubbing.)

≥Set [BASIC] >> [REC SPEED] >> [SP] to take pictures.

ªTo play back the sound recorded with

audio dubbing

You can switch between the sound recorded with audio dubbing and the original sound.

Set [SETUP] >> [12bit AUDIO] >> [ST2] or [MIX]. [ST1]: It only plays back the original sound. [ST2]: It only plays back the sound added by

audio dubbing.

[MIX]: It simultaneously plays back the original sound and the sound added with audio dubbing.

ªTo dub audio while listening to a

pre-recorded sound

≥When pausing the audio dubbing, set the [12bit AUDIO] on the [SETUP] Sub-Menu to [ST2] and you can check the pre-recorded sound. When the line input is used, you can dub audio while listening to the pre-recorded sound from the speaker.

50

LSQT0862