Panasonic PV-DV402 Replace the Battery, Remote Controlling Two Palmcorders, For VCR

Set the Remote Control to VCR 1 or VCR 2 to correspond with the Palmcorder you wish to control. (See above left.)

Before Using

Replace the Battery

B1While pressing the tab in the direction of the arrow (A) with

your fingernail, pull out the Battery Tray (B).

A

+

2Insert the battery into the Battery Tray with the + mark facing up.

Do not reverse the polarity.

3Insert the Battery Tray.

Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only. Use of another battery may present a risk of fire or explosion.

Caution: battery may explode if mistreated. Dispose of used battery properly. Keep away from children. Do not recharge, disassemble or dispose of in a fire.

Remote Controlling Two Palmcorders

You can control any two Panasonic Palmcorders with one Remote control. In order for the remote to distinguish between the two units, it is necessary to set one of the Palmcorders to VCR 2. On the remote, press VCR 1 or VCR 2 to control the desired Palmcorder.

For VCR 2 :	For VCR 1 :
Press these	Press these
buttons at the	buttons at the
same time.	same time.

Note

•When the Palmcorder and remote are not set to the same mode (VCR1 or

VCR2), “CHECK REMOTE MODE (REMOTE)” will appear.

1Set POWER to VCR or CAMERA.

•The POWER Lamp lights red.

•Be sure POWER is fully turned to VCR or CAMERA position.

2 Press MENU to display the VCR or CAMERA mode menu screen.

3 Rotate JOG KEY to select SET-UP in the CAMERA mode menu screen or PLAY MODE in the VCR mode menu screen, then press JOG KEY to display the CAMERA SET-UP or VCR PLAY MODE menu screen.

4 Rotate JOG KEY to select REMOTE , and then press JOG KEY to select VCR 2 (Menu OSD: pp. 109, 110). Leave the other Palmcorder set to

5 VCR1.

•After replacing the Remote Control Battery, the remote will default to VCR 1.

10
	Forassistance, pleasecall: 1-800-211-PANA(7262)orsende-mailto:consumerproducts@panasonic.com