Panasonic PV-DV402 Copying your Tapes to S-VHS or VHS Cassette, Monitor with your TV

Editing Features

Copying your Tapes to S-VHS or VHS Cassette

Before you begin

• Connect both Palmcorder and VCR to

their power sources.

• Connect the Palmcorder to a VCR as

Source (Playing) Palmcorder

DC Cable (Supplied)

A/V Cable (Supplied)

S-Video Cable (not supplied)

S-VIDEO OUT

A/V OUT

TV

(To View)

VHF Connecting Cable (not supplied)

Recording:

VCR (Rear)

Audio In Video In

illustrated left.

• Turn ON both units.

• Set the recording VCR’s Input Signal

Selector to LINE.

• Set the Palmcorder POWER to VCR.

• Before using S-VIDEO Connector,

insert the DC Cable into the DC IN

Terminal. (p. 15)

1 Insert a pre-recorded tape

into the source (playing) Palmcorder

and a blank tape, with record tab in

place, into the target VCR (Recorder).

2Press (PLAY) on the Palmcorder.

When the tape reaches the point you

want to start dubbing, press PAUSE.

3 Place the VCR into REC/PAUSE

mode. (See VCR manual.)

4 Simultaneously, press PAUSE on

both units to begin copying.

5 Press STOP on both units when

To Audio In

copying is completed.

Note

To Video In

To S-Video In

(If there is S-Video In)

	• For technical reasons, dubbing a tape
	may reduce its quality.
S-Video In	• Press DISPLAY ON TV on the
	Palmcorder Remote Control to eliminate
	EVF/LCD Monitor indications.
	• If the Time Code is displayed in the EVF
	or LCD monitor, it cannot be reset.
	• Only the DATE/TIME, when displayed,
	will be recorded on the tape.

Monitor with your TV

•Turn the TV ON and select its VCR channel (either CH3 or CH4).

•Set the VCR/TV Selector on the recording VCR to VCR.

CAUTION:

Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.

46
	Forassistance, pleasecall: 1-800-211-PANA(7262)orsende-mailto:consumerproducts@panasonic.com