Installation Procedure Connections | Kenwood KDC-D300 manual

Installation Procedure

Connections

English

The O-N switch should be set according to the Centre unit in use as well as to the connected models.

When the centre unit is compatible with the "N"-operation, set the O-N switch to "N". When it is not compatible with the "N"- operation, set the O-N switch to "O" because the operation is not available. The initial setting of the switch is "N".

1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.

2.Set the O-N switch of this unit to suit the centre unit.

3.Connect the speaker input cable to the front speaker cable of the wiring hernees of the centre unit.

4.Connect the control cable to the control connector.

5.Install the unit in your car.

6.Reconnect the - battery.

7.Press the reset button on the centre unit.

2CAUTION

• Do not connect the changer control cable while the centre unit

is turned ON.

• Be sure to press the reset button after installation.

• Whether the centre unit in use is compatible with the "N"-

operation or not can be identified by referring to its instruction

manual (description of the disc control mode, etc.).

• When this unit is connected with the KCA-S200 changer

Centre unit

Control input

White/Black

FRONT • L

White

Gray/Black

FRONT • R

Gray

Gray/Black

White

– +

Gray

switching unit, set the O-N switch to "O".

• Do not let unconnected wires or terminals touch metal on the

N O

car or anything else conducting electricity. To prevent a short

circuit, do not remove the caps on the ends of the unconnected

wires or the terminals.

• After the unit is installed, check whether the brake lamps,

blinkers, wipers, etc. on the car are working properly.

• Mount the unit so that the mounting angle is 30° or less.

2CAUTION

KDC-D300

Speaker input cable(Accessory4)

If the speaker input cable is not connected, or connected wrongly, the spectrum analyser will not be displayed.

— 10 —