Kenwood KDC-D300 instruction manual Eject

Page 14

English

Troubleshooting Guide

The following messages are displayed on the centre unit when certain problems are occurring in your system. Take the recommended actions.

E-01

No CD in the unit.

EJECT

]Insert the CD.

NO PANEL

The faceplate of this unit has been removed.

E-30

]Replace it.

E-04

The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.

 

]Clean the CD and load it correctly.

E-99

The unit is malfunctioning for some reason.

]Press the reset button on the centre unit. If the "E- 99" code does not disappear, consult your nearest service centre.

E-0d

The protective circuit in the unit activates when the temperature inside the CD player exceeds 60°C (140°F), stopping all operation.

HOLD

]Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the

 

disc will start playing again.

— 14 —

Image 14
Contents KDC-D300 Contents Do Not Load 3-in. CDs in the CD slot Safety precautionsTo prevent injury or fire, take the following precautions Marking of products using lasers Except for some areas Cleaning the Faceplate Terminals Cleaning the CD SlotCleaning the Unit Lens FoggingHandling Compact discs Operations Operation for N SettingOperation for O Setting Buttons and DisplaySwitching Spectrum Analyzer Display Presetting Disc NamesEnding the display level adjustment mode Display Level AdjustmentYou can adjust the spectrum analyzer level EjectExternal view Number of items AccessoriesReattaching Faceplate Installation Procedure Connections Installation InstallationRemoving the Unit EnglishRemoving the hard rubber frame Troubleshooting Guide Problem Possible CauseEject General SpecificationsSpecifications subject to change without notice