1 | 2 |
| 3 |
4
1
1
2
1
| OPEN/EJECT | 2 |
1 |
| 1 |
3 | PUSH | 4 |
CLOSE | ||
|
| 1 |
|
| R E C |
|
| SAVE |
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the Grip Belt to the size of your hand.
1Pass the longer loop of the Lens Cap Cord through the attached eye on the Lens Cap.
2Then pass the shorter loop of the Lens Cap Cord through the centre of the longer loop and pull tight.
3Attach the Lens Cap to the Grip Belt.
4Put your hand through the Grip Belt and adjust the length.
≥The removed Lens Cap can be hooked onto the Grip Belt 1. (When you are not recording, be sure to keep the Lens Cap attached to the Lens for protection.)
~~~~~~~~~~~~~~~~~~~~~~~~~
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going out of doors to record so as to avoid dropping the Movie Camera.
1Pull the end of the Shoulder Strap through the Shoulder Strap Holder on the Movie Camera.
2Fold the tip of the Shoulder Strap, run it through the
Shoulder Strap Length Adjuster, and pull it.
≥Pull it out more than 2 cm 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
~~~~~~~~~~~~~~~~~~~~~~~~~
Inserting a Cassette
When power is supplied to the Movie Camera, the Cassette can be taken out without turning the Movie Camera [ON].
1Slide the [OPEN/EJECT] Lever to the right and pull down to open the Cassette Compartment.
2Insert a Cassette.
3Close the Cassette Compartment and lock the Cassette Compartment by pressing the [PUSH CLOSE] mark.
4Close the Lower Cassette Compartment Cover.
ªAccidental Erasure Prevention
Opening the accidental erasure prevention slider 1 on the cassette (by sliding it in the [SAVE] arrow direction) prevents recording. To enable recording, close the accidental erasure prevention slider (by sliding it in the [REC] arrow direction).
≥For other notes concerning this item, see page 42.
11