ªTo Change the Display Mode
By changing [DISPLAY] on the [DISPLAY SETUP]
~~~~~~~~~~~~~~~~~~~
Warning/Alarm Indications
If any one of the following indications lights up or flashes, please check the condition of the Movie Camera.
3: | Condensation has occurred. (l46) |
Y: | The accidental erasure prevention |
| slider on the inserted Cassette is |
| open (that is, set to [SAVE]). |
| You are about to do audio dubbing |
| on the unrecorded (blank) portion of |
| the tape. |
| No Cassette is inserted. (l11) |
6: | The Battery is low. Recharge it. |
| (l10) |
0: | The |
:: | The video heads are dirty. (l47) |
2END: | The tape came to end during |
| recording. |
REMOTE: | Wrong Remote Controller Mode has |
| been selected. (l9) |
PRINTER ERROR: | The Video Printer is not connected |
| correctly, or the Video Printer is not |
| functioning properly. |
UNPLAYABLE TAPE |
|
(OTHER FORMAT): | You are attempting to play back a |
| tape section that has been recorded |
| with a different TV system. |
UNABLE TO A. DUB |
|
(LP RECORDED): | Because the original recording was |
| done in LP Mode, audio dubbing |
| cannot be performed. |
INCOMPATIBLE |
|
TAPE: | This Cassette is incompatible. |
PLEASE | |
AFTER PUSHING |
|
RESET BUTTON: | Mechanism Irregular is detected. |
| Press the [RESET] Button (l7). |
| This may solve the problem. |
TO SERVICE: | It is a malfunction. |
CARD FULL: | Card does not have sufficient |
| memory remaining. |
NO CARD: | Card is not inserted. |
NO PICTURE: | Card has no pictures recorded on it. |
CARD ERROR: | This Card is not compatible with this |
| Movie Camera. |
COPY INHIBITED: | Because the medium is protected by |
| a copy guard, images cannot be |
| recorded correctly. |
~~~~~~~~~~~~~~~~~~~
Notes and Hints
ªConcerning the Power Supply
≥When the Movie Camera is used for a long time, the Camera body becomes warm, but this is not a malfunction.
≥If the [CHARGE] Lamp does not light up although the Battery is attached to AC Adaptor, detach the Battery and reattach it.
≥Battery
ªInserting/Removing the Cassette
≥In the case of using a previously recorded Cassette, you can use the Camera Search Function to find the position where you want to continue recording.
≥If a new Cassette is inserted, rewind to the beginning of the tape before starting recording.
≥When inserting the cassette, make sure it faces in the right direction and then push it in until it stops.
≥When opening or closing the Cassette Compartment, push down the buckle of the Grip Belt so that it does not obstruct the opening and closing of the Cassette Compartment.
ªAlarm Sounds
When [BEEP SOUND] on the [OTHER FUNCTIONS]
1 Beep
≥When you start recording
≥When you switch the [OFF/ON/MODE] Switch from [OFF] to [ON]
2 Beeps
≥When you pause recording 10 Beeps
≥If you perform a wrong operation before or during recording
ªRecording
≥Before turning on the power, remove the Lens Cap. If the Lens Cap is still attached when the power is turned [ON], Automatic White Balance Adjustment (l50) may not function correctly.
ªRecording Check
≥For Recording Check, the recording speed mode (SP/LP) must be the same as the mode used for the recording. If different, playback images will be distorted.
ªCamera Search
≥In Camera Search Mode, images may contain
≥If the recording speed modes (SP/LP) of previous recording and new recording are different, playback images may be distorted.
ªPhotoshot
≥Photoshot Recording results in slightly inferior image quality.
ªProgressive Photoshot Function
≥The still pictures are recorded at a slightly rewound point from where you press the [PHOTO SHOT] Button.
≥When you change to the Still Picture Mode, you will hear a click. This is the sound of the iris closing and not an indication of malfunction.
≥If you record still pictures in Progressive Photoshot Mode
when your Movie Camera is set to Programme AE (l22), the brightness of the images may change.
About [PROGRESSIVE] Setup
≥When the [æ] Indication is displayed, you can use the Progressive Photoshot Function.
42