Setup 2 | Charging time, recordable time and |
Remaining battery capacity indication |
Charging time and recordable time
Times are given for a temperature of 25 ˚C and humidity of 60 %. The charging time shown in the table are approximations. In high or low temperatures, charging requires more time.
●Supplied battery
Charging time | Approx. 2 h 15 min | ||
| Maximum continuously | Actual recordable time | |
Recordable time | recordable time | ||
| |||
| Approx. 1 h 15 min | Approx. 40 min |
●Actual recordable time includes recording and stopping, turning the unit ON/ OFF, zooming and other operations.
●Recordable time varies according to conditions of use. For example, the recordable time shortens when the [POWER LCD] setting is on while recording.
●The recordable time shortens in some environments (i.e., low temperatures, etc.), therefore it is recommended to charge a spare battery.
Remaining battery capacity indication
The battery indication changes, as the remaining battery power decreases.
High Low
Flashing (Charge battery.)
It has been found that counterfeit battery packs which look very similar to the genuine product are available to purchase in some markets. Some of these battery packs are not adequately protected to meet the requirements of appropriate safety standards.
These battery packs may lead to fire or explosion. Please be advised that we are not liable for any accident or failure occurring as a result of use of a counterfeit battery pack. To ensure that safe products are used we would recommend that a genuine Panasonic battery pack is used.
Setup 3 Inserting/Removing SD
cards (sold separately)
SD cards are sold separately. Preparations: Set the mode dial to [OFF].
(Check that the status indicator is out.)
Inserting or removing an SD card while the unit is turned on may damage the unit and destroy data on the card.
1 Opendoor. the card/battery
Open the door by sliding the card/ battery door lever to the “OPEN” position.
2 Insert/Removecard. the SD
•To insert: |
| |
Face the label upwards and slide |
| |
the card in straight until hearing it |
| |
catch. |
| |
•To remove: | Place label upwards. | |
Press the centre of the SD card and | ||
| ||
pull the card out straight. |
|
3 Closedoor. the card/battery
•Close the card/battery door and slide the card/battery door lever to the “LOCK” position.
•If the door does not close completely, remove the SD card, check its orientation and reinsert it into the slot.
●While the card access lamp is lit, reading, recording, playback, deletion or other processing is being executed. Performing the following operations while the lamp is lit may damage the SD card and its content and the unit may not function properly.
•Turning off the unit
•Removing battery or AC adaptor
•Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
• Disconnecting the USB cable
●The access lamp is supposed to light up while rotating the dial to select a mode. In this case, there is no problem.
16 LSQT1438 | LSQT1438 17 |