Other features (See page 8)
English
Audio Control Setting
Adjust various parameters of sound quality.
1Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode display changes as follows:
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
If you do not move to step 2 in 5 seconds, the unit will switch back to the volume adjustment mode (i.e., the normal mode).
NOTE Source tone memory
Each source (CD, FM, and AM) has its own memory in which to store the bass and treble tone settings.
The settings made for a particular source are then recalled automatically whenever you use that source (e.g., FM mode uses the tone settings made for FM, AM for AM, etc.).
2Press the d/u buttons to adjust the mode shown in the display.
Use the following table as a guide for adjusting the settings in each mode.
Adjustment | Operation of Audio control button | ||
mode |
|
| |
(Display) | d button | u button | |
Bass | Bass decreased. | Bass increased. | |
(“BAS”) | |||
|
| ||
|
|
| |
Treble | Treble decreased. | Treble increased. | |
(“TRE”) | |||
|
| ||
|
|
| |
Balance | Left channel | Right channel | |
(“BAL”) | emphasized. | emphasized. | |
|
|
| |
Fader | Rear channel | Front channel | |
(“FAD”) | increased. | increased. | |
|
|
| |
Clock Display
Display the time.
Switching to Time Display:
Press the CLK button repeatedly until the clock is displayed.
Adjusting Time
When the RDS station tuned into is transmitting a time signal, have the unit’s
Adjusting the Time:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
NOTE
•The displayed time cannot be set manually, but only through RDS station time signals.
•The time is not adjusted when the RDS station you are tuned to is not transmitting a time signal. Choose another RDS station in such a case.
— 20 —