Do not carry the unit when it is still attached to the camera body.
≥Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning.
–In direct sunlight or on a beach in summer
–In locations with high temperatures and humidity levels or where the changes in temperature and humidity are acute
–In locations with high concentrations of sand, dust or dirt
–Where there is fire
–Near heaters, air conditioners or humidifiers
–Where water may make the unit wet
–Where there is vibration
–Inside a vehicle
≥Refer also to the operating instructions of the digital camera.
≥When the unit is not going to be used for a prolonged period, we recommend storing with a desiccant (silica gel). Failure to do so may result in performance failure caused by mold, etc. It is recommended that you check the unit’s operation prior to use.
10
≥Do not leave the lens in contact with rubber or plastic products for extended periods of time.
≥Do not touch the lens contact point. Doing so can cause failure of the unit.
≥Do not disassemble or alter the unit.
Do not use benzine, thinner, alcohol or other similar cleaning agents to clean the lens glass or exterior cabinet.
≥Using solvents can damage the lens or cause the paint to peel.
≥Wipe off any dust or fingerprints with a soft, dry cloth.
≥Use a dry, dust cloth to remove dirt and dust on the focus ring.
≥Do not use a household detergent or a chemically treated cloth.
Troubleshooting
A sound is heard when the camera is turned on or off.
≥This is the sound of lens or aperture movement and is not a malfunction.
VQT2W38