Samsung C6435(P), SCC-C6433(P) manual White BAL

Page 48

WHITE BAL

Lights are generally denoted as colour temperatures and expressed in Kelvin (K) units. The general light colour temperatures are shown below.

10000K

9000K

8000K

7000K

6000K

5000K

4000K

3000K

2000K

1000K

Blue sky

Rainy

Cloudy

Partly Cloudy

Sunny

Fluorescent lamp

Halogen lamp

Tungsten lamp

Candlelight

You can select one of four modes for white balance adjustment as follows:

-ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the colour temperature is monitored continuously and thereby white balance is set automatically. The following are the approximate supported colour temperature ranges in these modes.

ATW1 : 2500K ~ 9300K(*1)

ATW2 : 2000K ~ 10000K(Mode recommended for sodium lighting)(*2)

*1. If the colour temperature is out of this range in ATW1 mode, proper white balance may not be obtained. In that case, select ATW2 mode.

*2. In ATW2 mode, if one colour is dominated in the shot area, the colour can be displayed differently. Therefore, select the mode which is appropriate for the environment.

-AWC8 (Auto-Tracing White Balance Control): In this mode, accurate white balance is obtained by pressing the ENTER while having a white paper in front of the camera. White Balance data will be maintained after set it once. AWC mode is best in locations where the colour temperature of light source is constant.

48

Image 48
Contents SCC-C6433P/C6435P SmartDome CameraSafety Precautions ENG Important Safety Instructions Contents Digital Zoom Display Zoom Display P/T Exit System info Shortcut keys Main features OverviewAbout this guide Product overviewNames of Each Part Camera Holder Adapter Camera Body Zoom Lens Cover-domeInstallation Before installationInitial setting Things to Keep in Mind During Installation and USESetting Communication Protocol Baud Rate Setting Setting RS-422A/RS-485 Termination TX+DATA+ SW1-ON TX-DATA RX+ RX CAMCAM n-1 RS-422A/RS-485 Full Duplex Organization Adapter cable connection Cable connection Video terminal on the rear of monitor BNC CablePower Selection Switch under the Power Adaptor Adapter Cable Controller Installation precautions Separately sold products for installationWall Mount Adaptor SADT-104WM Outdoor Housing SHG-222 Ceiling Mount Adaptor SADT-100CM Corner Mount Adaptor SADT-110CM Installing the camera BRACKET-CEILING BRACKET-CELING ASSY-HOLDER Camera ENG Camera Setup Preset Preset MAP Selectable languages may vary depending on sales region ① Password Undefined ② Password Defined Camera setup Camera IDSync DAY/NIGHT DAY NightAUTO… Motion DET Those 3 types are like the following Block Type Zoom Speed Digital ZoomDisplay Zoom Display ZOOM, you can display the Zoom scale on the screenDisplay P/T ExitVideo set IrisManu Level RET Manu Shutter WDRAGC White BAL ATW2 Focus Mode Oneaf Special Exit Quit MotionWhite BAL Focus Mode Exit Quit RETSpecial DNR FlickerlessReverse DetailPOSI/NEGA SavePreset Preset ID Preset SpeedPosition SET Video SETZone set Privacy ZoneZone DIR SET Zone Area SET Location Zone Enable Zone ID SETAuto set Auto PANDirection EndlessSpeed Pattern Scan Auto Play Auto ReturnAuto Play Play NumberAlarm set Alarm Priority SET Alarm in SETAlarm OUT SET Auto SETOther set Proportional P/TTurbo P/T Auto CALCAM Reset FlipLanguage Password Clock set RS-485System info Shortcut keys Auto Return *1 SCC-6435 Product Specifications Details50IRE Size Memo Correct Disposal of This Product