Memorex MDF8402-DWD, MDF8402-LWD manual AC Connection

To DC 5V IN Jack

AC CONNECTION

Insert the small end of the AC adapter into the DC 12V IN jack (located under the left cover on the side of this unit). Connect the other end to a wall outlet having 120V AC, 60 Hz.

AC Adapter, DC 12V Z

NOTES:

• Remove both the DC plug and the AC- IN plug to disconnect the AC adapter when not in use.

• Only use the supplied AC adapter which has the following specs: DC 12V Z

REMOTE BATTERY INSTALLATION 1.

2.

3.

Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out.

Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up).

Replace the Battery Compartment.

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

1. Warning–Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.

2. Use only the size and type of batteries specified.

3. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartments. A reversed battery may cause damage to the device.

4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s directions.)

6