CBC CX Series RED Black White Green, +12VDC/24VAC, Adjusting Camera Orientation, Lens Adjustment

Page 4

CX Series Instruction Manual

RED BLACK WHITE GREEN

+12VDC/24VAC

POWER GROUND/24VAC VIDEO SIGNAL OUT VIDEO GROUND

MOUNTING THE CAMERA

The camera base has two mounting holes for #8 screws (#8 screws and anchors are supplied). To mount the camera, loosen the swivel set screw with the 1/8” Allen wrench (supplied) and mount the base in the desired location. The mounting base can be removed completely from the bracket if necessary.

ADJUSTING CAMERA ORIENTATION

Loosen the swivel set screw and rear end cap set screw with supplied Allen keys. Orient the camera and tighten both set screws. Be sure to tighten the rear end cap set screw to maintain a water-tight seal.

LENS ADJUSTMENT

1)Completely loosen the two Phillips screws on the rear endcap that hold the housing cover in place, and remove the cover.

2)Loosen the focus and zoom adjustment locking screws.

3)Connect the camera to power and a monitor to adjust focal length and focus for best image.

4)Tighten focus and zoom locking screws. Recheck image after tightening.

5)Replace cover carefully in order to prevent damage to the camera components.

6)Make sure cover is tight against back plate and tighten two Phillips screws on housing with equal force.

Page 2

Image 4
Contents CX Series Contents Wiring Connections Major FeaturesBasic Description Adjusting Camera Orientation Lens AdjustmentRED Black White Green +12VDC/24VACFCC Rules Part DIP Switch Setup Color Cameras Iris FL BLC SyncDIP Switch Setup Black and White Cameras Iris AGC BLC SyncCamera Specifications CX-NV310A-2 Color/CXH-NV310A-2 Hi-Res ColorCX-EV310A-2 B&W Camera AGCDXH-NV39A Hi-Res Color Day/Night Adjustment Ring Focus Lock Screw Dip Switch Adjustments Model CX-EV310A-2 B/W Camera ComponentsTOKYO, Japan COMMACK, NEW York TORRANCE, California