LTC9412/00
Table of Contents
1DESCRIPTION
2UNPACKING
3SERVICE
4INSTALLATION
5EXPLODED VIEW
Instruction Manual Introduction
EN 2
2
2
2
2
3
1 DESCRIPTION
The LTC9412/00 is a 12” pendant mount ceiling dome for indoor applications. The housing top is black ABS plastic
2 UNPACKING
Unpack carefully. This is a mechanical equipment and should be handled carefully.
Check for the following items:
• Model No. of unit
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch CSS Sales Representative or Cus- tomer Service.
The shipping carton is the safest container in which the unit may be transported. Save it for possible future use.
3 SERVICE
If the unit ever needs repair service, the customer should contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions.
Service Centers
U.S.A.: Phone:
Canada:
Europe, Middle East & Asia Pacific Regions:
For additional information, see www.boschsecuritysystems.com
4 INSTALLATION
This installation should be made by qualified service personnel and conform to the National Electrical Code and applicable local codes.
!proceeding, and heed all cautions.
4.1.Remove contents from the box and check to be sure all pieces are included.
4.2.Select the desired location for the installation. It must be a secure mounting structure, and the completed installation must be able to support 3 times its weight.
4.3.Determine the desired height for the unit. Measure from the ceiling to the top of the housing (the housing is approximately 18” tall). Add 8” for the interior of the LTC9412. Obtain 1/2” electri- cal conduit and hardware to mount to the ceiling. Cut the conduit to the measured length. Mount the conduit to the ceiling.
4.4.Slide the Clamp Connector and housing up the conduit so that
the end of the conduit is approximately level with the bottom of the housing. Tighten the 2 Phillips head screws (Figure 1).Please read these instructions carefully before
Clamp connector with 2 Phillips head screws
Figure 1 Slide housing and connector onto conduit
4.5.Completely seat the EMT connector to the end of the conduit and tighten the set screw (Figure 2).
Figure 2 Place the EMT connector on the conduit
Bosch Security Systems 14 November 2003