Liebherr RI 1410/ RBI 1410/ FI 1051 manual Installing the water filter, Connecting the appliance

Fig. 76

Fig. 77

Installing the water filter

14 Installing the water filter*

The water filter guarantees optimal water quality and should be installed the first time you use the appliance. Alternatively, the appliance can also be operated without the water filter.

uOpen the filter change flap Fig. 76 (3).

uCarefully pull out drawer Fig. 76 (4) by the string

Fig. 76 (5).

uCut off the string Fig. 76 (5) together with the label Fig. 76 (2) and pull out. It is no longer required and can be disposed of.

Flow rate

Water connection

Water pressure

Water temperature Capacity

0.5gpm (1.89 lpm) Drinking water

40 psi - 90 psi ( 2.8 bar - 6.2 bar/ 0.28 MPa - 0.62 MPa )

33 °F - 100 °F ( 0.6 °C - 37 °C )

300 gal. (1.14 l)

WARNING

Consuming contaminants can be harmful to your health! u If there is a chance the water may contain harmful

bacteria or if the water quality is unknown, do not use this system without appropriate disinfection measures upstream or downstream of the system.

NOTICE

Leakage water may damage the system!

u Do not install this system on hot water lines. The maximum operating temperature of the water in this system is 100 °F (37.7 °C).

u This system MUST be installed and used in compliance with federal and local installation regulations.

u Do not install under water hammer conditions. A water hammer arrestor must be used to prevent water hammering. If you are unsure how to check these conditions, consult a professional installer.

u Do not install with a water pressure greater than 90 psi (6.2 bar). If your water pressure exceeds 80 psi, install a pressure limiting valve. If you are unsure how to check the water pressure, consult a professional installer.

u Protect against frost; if temperatures below 33 °F (0.6 °C) are expected, remove the filter.

u When used as indicated, the disposable filter cartridges must be replaced every 6 months or whenever you notice a considerable decrease in the flow rate.

u If necessary, remove ventilation grille Fig. 77 (1). u Remove any labels Fig. 76 (2) from the appliance.

u Remove the filter cover Fig. 77 (6).

u Insert water filter Fig. 77 (7) and turn it approximately 100° clockwise as far as it will go.

u Insert the drawer Fig. 77 (4).

u Place the cover Fig. 77 (6) on the filter.

u Write the date of the next filter replacement on the label Fig. 77 (8) supplied and affix it to the filter cover Fig. 77 (6).

u Close the filter change flap Fig. 76 (3). u Fit ventilation grille Fig. 77 (1).

u Make sure the filter is leak-tight and no water is coming out.

Note

New water filters may contain particulate matter and must be rinsed through before use.

u To achieve this, do not consume or use the ice cubes that are produced within 72 hours after the filter is replaced.

w The water filter is now ready for use.

15 Connecting the appliance

WARNING

Electrical shock hazard!

u Start-up should only take place once the appliance has been installed according to these instructions.

u Electrically ground appliance. u Do not ground to a gas pipe.

u Check with a qualified electrician if you are not sure the appliance is properly grounded.

u Do not have a fuse in the neutral or grounding circuit. u Do not use an extension cord, power bar or a multiple

socket adapter.

u Do not use a power cord that is frayed or damaged.

33