Changing the door hinges
u Close the door.
Fig. 31
u Unscrew bearing part Fig. 32 (28), turn it 180° and tighten Fig. 32 (29).
u Remove bearing disc Fig. 32 (26) from bearing pin Fig. 32 (27).
u Unscrew bearing pin Fig. 32 (27), move to other side and place bearing disc Fig. 32 (26) on.
u Using a cordless screwdriver if necessary, attach the bearing bracket Fig. 32 (20) to the new hinge side . First fit the lower center screw, then the other screws.
8.5 Swapping the clip-on frame
u Pull cover Fig. 31 (10) forward and then upwards to remove.
u Lift off cover Fig. 31 (11).
CAUTION
Risk of injury if the door tips out! u Keep a steady grip on the door. u Set the door down carefully.
u Unscrew upper bearing bracket Fig. 31 (12)(2 x Torx 25) Fig. 31 (13) and pull it upwards to remove.
u Lift the door upwards to remove and set it to the side.
8.4 Swapping bearing parts
Fig. 32 u Unscrew bearing bracket Fig. 32 (20) together with bearing pin Fig. 32 (27)(3 x Torx 25) Fig. 32 (21). When doing so, hold panel Fig. 32 (22) steady so that it does
not drop.
u Carefully lift off the cover on the handle side Fig. 32 (23) and the plug Fig. 32 (24) and move them to the opposite side.
u Unscrew screw Fig. 32 (25) and move it to the opposite side. When doing so, hold panel steady so that it does not drop.
Fig. 33
u Unscrew the part of the frame that is on the hinge side Fig. 33 (30). Ensure that the top and bottom bushes Fig. 33 (31) do not fall out.
u Unscrew the part of the frame that is on the handle side Fig. 33 (32) and screw it onto the opposite side. Do not overtighten the screws!
When assembling the frame parts ensure that the corners fit together as snugly as possible.
If a framed panel (see 7) is used:
u Unscrew the part of the frame that is on the hinge side Fig. 33 (30) and screw it to the opposite side. Do not overtighten the screws!
8.6 Fitting the door
u Move bearing pin Fig. 31 (14) in upper bearing bracket to other side Fig. 31 (12).
u Ensure that the bearing disc Fig. 32 (26) is on the bearing pin below Fig. 32 (27).
u Position the door from above onto the bearing pins below Fig. 32 (27).
u Close the door.
u Insert the upper bearing bracket Fig. 31 (12) on the new hinge side into the door.
u Secure upper bearing bracket Fig. 31 (12)(2 x Torx 25) Fig. 31 (13). Make preliminary holes (optional) or use a cordless screwdriver.
u Snap both cover Fig. 31 (10) and cover Fig. 31 (11) into place on the opposite side.
21
