Changing the door hinges
u Completely loosen cover that is on the hinge side Fig. 26 (5) and remove.
u Remove panel Fig. 26 (1). u Loosen cover that is on the hinge side Fig. 27 (6) using a screwdriver and
remove by pulling outwards.
u Unscrew spacer Fig. 26 (60) .
Fig. 27
u Unscrew soft stop unit (2 x Torx 15) Fig. 26 (7).
u Slightly pull out soft stop unit, push it towards the handle side and open it out.
u Set soft stop unit to the side. u Unscrew bearing part Fig. 28 (8), turn it 180° and move it to the opposite side. Make preliminary holes (optional) or use a
cordless screwdriver.
Fig. 28
8.2 Remove soft stop unit (bottom)
Fig. 29
u Open the door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close properly and the level of cooling is insufficient.
u Do not damage the door seal with the screwdriver!
u Release panel Fig. 29 (1) using slotted screwdriver and remove.
w The panel hangs above the damper bracket.
Fig. 30 u Push panel forward over the damper bracket Fig. 30 (55)
in the direction of the appliance.
WARNING
Risk of injury if the soft stop mechanism contracts!
If the locking device is not fitted, the soft stop mechanism contracts during disassembly and can jam your fingers.
uFit the locking device!
uEngage locking device Fig. 30 (53) into place inside oblong hole.
The locking device prevents the hinge from snapping shut.
Lift off cover Fig. 30 (52) from the outside using a screwdriver and remove by pulling outwards.
Push bolt Fig. 30 (54) out from below.
Press damper bracket Fig. 30 (55) in the direction of the door.
Remove panel Fig. 30 (51). Unscrew spacer Fig. 30 (58) .
Unscrew entire soft stop unit (2 x Torx 15) Fig. 30 (56). Slightly pull out soft stop unit, push it towards the handle side and open it out.
Set soft stop unit to the side.wuuuuuuuu
8.3 Remove door
Note*
u To prevent food items from falling out, take all food out of the door racks before removing the door.
20
