u Completely raise the levelling wheels at the front and back of the two center roller bases Fig. 71 (50) such that the attached appliances are resting on the outer roller bases only.
u Align appliance inside the recess by adjusting the outer roller bases Fig. 71 (51) and using a spirit level.
u At the top and bottom of the recess check the gap A between the front edge of the installation strip Fig. 71 (3) and the front edge of the side wall of the unit. It must be 1/2 ” (13 mm). Realign the appliance in the recess if required.
u Secure appliance inside the recess using three screws Fig. 71 (52) hinge side of each appliance. Do not scratch the side installation strip Fig. 71 (3) when doing so.
u Place cover caps Fig. 71 (53) over the screws.
u Being careful not to affect the level, lower the levelling wheels in the center roller bases Fig. 71 (50) until they are resting on the floor.
You can use either your own handles (that match the kitchen cabinets) or handles from the manufacturer that have been ordered separately.
Fig. 72
If a water filter is used:
u Insert water filter (see 14) .* If no water filter is used:
u Fit lower ventilation grille Fig. 71 (54) flush with the floor such that the rubber lip is at the top. It is held in place via magnets.
u Fit décor panels (see 7) .
Fit handles (framed panel):
Fig. 73
u Push handles Fig. 73 (60) into the openings in the door and screw on Fig. 73 (61). Press cover trim Fig. 73 (62) into position.
Fit handles (overlay panel):
Fig. 74 Handles from the manufacturer Ø 3/4” (18 mm)
Fig. 75 Handles from the manufacturer Ø 1” (25mm)
u Fit handles to the overlay panel Fig. 75 (63)as shown in the diagram.
32
