Fig. 63
u Glue spacer Fig. 63 (72) onto the lower part of the side wall on the handle side, approximately 1.5 in. (40 mm) as measured inwards from the front edge of the appliance.
Fig. 64
u Align the height of both appliances evenly using the four roller bases. Use upper adjustment setting (1/4”) Fig. 64 (70) for the rear adjustable foot and lower adjustment setting (1/4”) Fig. 64 (71) for the front adjustable foot respectively. Turn clockwise to raise and counterclockwise to lower. Maximum adjustable height: 5/8 in (16 mm).
u Position end strip Fig. 61 (14) over the installation contour and align it such that the holes in ventilation grille and installation contour are above each other.
u Screw on upper installation contour Fig. 61 (14) through the
Fig. 65
u Secure upperconnecting element Fig. 65 (11) using two screws Fig. 65 (12). Make preliminary holes (optional) or use a cordless screwdriver.
uClip on cover panel Fig. 65 (13).
uPush appliances together at the bottom and realign if necessary.
Fig. 66
u Remove the spacers Fig. 66 (20) from the lower reverse side of the appliances.
u Position lower connecting piece Fig. 66 (21) such that the screw holes are above each other and screw Fig. 66 (23) on from the side.
u Position upper connecting piece Fig. 66 (22) and screw Fig. 66 (23) on from the side.
Fig. 67
u Insert long carriage bolt Fig. 67 (73).
u Push washer Fig. 67 (74) and nut Fig. 67 (75) onto the screw. Tighten nut until the spacer Fig. 67 (72) is touching the opposite side wall.
u Fit strip Fig. 65 (16), push it slightly under the top cover Fig. 65 (13) and then press it downwards into the gap.
u Tighten the screws Fig. 66 (23).
Note
u Depending on the recess height, you will need to install a ventilation grille (80”), a ventilation grille (84”) or an end strip. Observe the necessary ventilation cross- sections (see 5) .
Fit upper ventilation grille (80” or 84”):
30
