Lenovo W510, T510I manual Numeric error codes

•“Intermittent problems” on page 50

•“Undetermined problems” on page 51

The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most likely cause is listed first, in boldface type.

Note: Do the FRU replacement or other actions in the sequence shown in the column headed “FRU or action, in sequence.” If replacing a FRU does not solve the problem, put the original part back in the computer. Do not replace a nondefective FRU.

This index can also help you determine, during regular servicing, what FRUs are likely to need to be replaced next.

A numeric error is displayed for each error detected in POST or system operation. In the displays, n can be any number.

If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not described there, go to “Intermittent problems” on page 50.

Note: For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for that device.

Numeric error codes

Table 2. Numeric error codes

Symptom or error	FRU or action, in sequence
0175	System board.
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
0176	1.	Run BIOS Setup Utility, and save the current
System Security—The system has been tampered with.		setting by pressing F10.
	2.	System board.
0177	System board.
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0182	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad CRC2. Enter BIOS Setup and load Setup		load the default setting. Then save the current
defaults.—The checksum of the CRS2 setting in the		setting by pressing F10.
EEPROM is not correct.	2.	System board.
0185	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad startup sequence settings. Enter BIOS Setup and		load the default setting. Then save the current
load Setup defaults.		setting by pressing F10.
0187	System board.
EAIA data access error—The access to EEPROM is failed.
0188	System board.
Invalid RFID Serialization Information Area.
0189	System board.
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190	1.	Charge the battery pack.
Critical low-battery error	2.	Battery pack.

44ThinkPad T510, T510i, and W510 Hardware Maintenance Manual