Lenovo T510I, W510 manual PC-Doctor for Rescue and Recovery, FRU tests

PC-Doctor for Rescue and Recovery

In some models of ThinkPad Notebook, the Rescue and Recovery® workspace enables you to run the PC-Doctor program to test the hardware features of the computer.

To run the test, click “Run Diagnostics” on the Rescue and Recovery main screen.

FRU tests

The following table shows the test for each FRU.

Table 1. FRU tests

FRU	Applicable test
System board	1. Diagnostics ➙ CPU/Coprocessor
	2.	Diagnostics ➙ Systemboard
	3.	If the docking station or the port replicator is attached to the ThinkPad Notebook,
		detach it.
	4.	Place the computer on a horizontal surface, and run Diagnostics ➙ ThinkPad
		Devices ➙ HDD Active Protection Test.
		Note: Do not apply any physical shock to the computer while the test is running.
Power	Diagnostics ➙ ThinkPad Devices ➙ AC Adapter ➙ Battery 1 (Battery2)
LCD unit	1. Diagnostics ➙ Video Adapter
	2.	Interactive Tests ➙ Video
Audio	Enter the BIOS Setup Utility and change Serial ATA (SATA) setting to Compatibility,
	and run Diagnostics ➙ Other Device ➙ Conexant Audio
Speaker	Interactive Tests ➙ Internal Speaker
	Note: Once Audio test is done, the no sound is heard this test. In this case, turn off
	and turn on the computer. Then, run this test again.
Keyboard	1. Diagnostics ➙ Systemboard ➙ Keyboard
	2.	Interactive Tests ➙ Keyboard
Hard disk drive or solid state	Enter the BIOS Setup Utility and change Serial ATA (SATA) setting to Compatibility,
drive	and run Diagnostics ➙ Fixed Disks
	You can also diagnose the drive without starting up the operating system. To diagnose
	the drive from the BIOS Setup Utility, do as follows:
	1.	Remove any diskette from the diskette drive, and then turn off the computer.
	2.	Turn on the computer.
	3.	While the message, “To interrupt normal startup, press the blue ThinkVangate
		button,” is displayed at the lower left of the screen, press F1 to enter the BIOS
		Setup Utility.
	4.	Using cursor keys, select HDD diagnostic program. Press enter.
	5.	Using cursor keys, select Main hard disk drive or Ultrabay hard disk drive.
	6.	Press Enter to start the diagnostic program.
Diskette drive	1.	Diagnostics ➙ Diskette Drives
	2.	Interactive Tests ➙ Diskette
Optical drive	1.	Diagnostics ➙ Other Devices ➙ Optical Drive
	2.	Interactive Tests ➙ Optical Drive Test
Memory	1. If two DIMMs are installed, remove one of them and run Diagnostics ➙ Advanced
		Memory Tests.
	2.	If the problem does not recur, return the DIMM to its place, remove the other one,
		and run the test again.

34ThinkPad T510, T510i, and W510 Hardware Maintenance Manual