Changing the door hinges
8.7Fitting the soft stop mechanism (bottom)
8.8 Fitting soft stop mechanism (top)
Fig. 34 u Loosen cover Fig. 34 (57) from the panel Fig. 34 (51) and
insert on the other side.
u With the hinge of the soft stop unit facing the door hinge side, engage the soft stop unit (A) and swivel inwards (B).
w The holes on the left and right must lie exactly above each other.
u Tighten soft stop unit (2 x Torx 15) Fig. 34 (56). u Screw on spacer Fig. 34 (58) .
Fig. 35
u Hook panel Fig. 35 (51) into the damper bracket such that the detent hooks are pointing forward and the front side is facing the appliance.
u Pull damper bracket Fig. 35 (55) towards bearing part Fig. 35 (28) and insert bolt Fig. 35 (54) from above such that the square is resting in the recess.
u Place cover Fig. 35 (52) on top and snap into place.
w Check that the cover is positioned correctly such that the door can close properly and the bolt is secured.
u Remove locking device Fig. 35 (53) by twisting it. u Snap panel Fig. 35 (51) into place on the door. u Close the door.
Fig. 36 u Loosen cover Fig. 36 (9) from the panel Fig. 36 (1) and
insert on the other side.
u With the hinge of the upper soft stop unit facing the door hinge side, engage the soft stop unit (A) and swivel inwards (B).
w The holes on the left and right must lie exactly above each other.
u Tighten soft stop unit (2 x Torx 15) Fig. 36 (7). u Screw on spacer Fig. 36 (60) .
Note
u Follow the correct sequence. First hang the panel over the damper bracket, then the cover.
Fig. 37
u Hook panel Fig. 37 (1) into the damper bracket Fig. 37 (4) such that the detent hooks are pointing inwards and the front side is facing the appliance.
u Push on cover Fig. 37 (5) from the outside (A) and pivot over the bearing part Fig. 37 (8) (B).
u Place cover Fig. 37 (5) on top and allow to snap into place until the first notch.
w The openings for the bolts lie above each other after positioning the damper bracket.
u Pull damper bracket Fig. 37 (4) towards bearing part and insert bolt Fig. 37 (3) from above such that the square is resting in the recess.
u Now snap cover Fig. 37 (5) completely into place on the bearing part Fig. 37 (8).
w Check that the cover is positioned correctly such that the door can close properly and the bolt is secured.
22
