Single unit installation
NOTICE
Risk of damage due to leaking water!
u When pushing the appliance into the recess ensure that the water connection does not kink or become damaged.
Fig. 52
u Push the appliance into the recess until the rear edge of the ventilation grille Fig. 52 (10) is flush with the front edge of the side wall of the cabinet.
u Open the door.
u Align appliance inside the recess above the roller bases Fig. 52 (33) using a spirit level: Use upper adjustment setting (1/4”) Fig. 52 (34) for the rear adjustable foot and lower adjustment setting (1/4”) Fig. 52 (35) for the front adjustable foot respectively. Turn clockwise to raise and counterclockwise to lower. Maximum adjustable height: 5/8 in (16 mm).
u At the top and bottom of the recess check the gap A between the front edge of the installation strip Fig. 52 (3) and the front edge of the side wall of the unit. It must be 1/2 ” (13 mm). Realign the appliance in the recess if required.
u Secure appliance inside the recess using three screws Fig. 52 (30) on the handle side and the hinge side respectively. Do not scratch the side installation strip Fig. 51 (3) when doing so.
u Place cover caps Fig. 52 (31) over the screws.
Fig. 53
If a water filter is used:
u Insert water filter (see 14) .* If no water filter is used:
u Fit lower ventilation grille Fig. 53 (32) flush with the floor such that the rubber lip is at the top. It is held in place via magnets.
u Fit décor panels (see 7) .
Fit handles (framed panel):
Fig. 54
u Push handles Fig. 54 (60) into the openings in the door and screw on Fig. 54 (61). Press cover trim Fig. 54 (62) into position.
Fit handles (overlay panel):
You can use either your own handles (that match the kitchen cabinets) or handles from the manufacturer that have been ordered separately.
27
